MIKROE-473 MikroElektronika

Manual ACCEL SPI BOARD All Mikroelektronikas development systems feature a large number of peripheral modules expanding microcontrollers range of application and making the process of program testing easier. In addition to these modules, it is also possible to use numerous additional modules linked to the development system through the I/O port connectors. Some of these additional modules can operate as stand-alone devices without being connected to the microcontroller. MikroElektronika Additional boardACCEL SPI BOARD Accel SPI Board is used to measure acceleration and gravity. The measurement on the additional board is performed by using the ADXL345 accelerometer circuit. The additional board is connected to the microcontroller on the development board via pads and communicates with the microcontroller by using serial SPI interface. Eight pads for connecting the additional board to the microcontroller on the development system or to some device Figure 1: Accel SPI Board Figure 2: Accel SPI Boards back side Accel SPI Board is a low-power additional board, thus making it suitable for integrating into mobile devices. The additional board is used to measure dynamic and static acceleration in 13-bit resolution ranging +/- 16g. Accel SPI Board pins funtion: ACL-CS - Chip select INT1 - Interrupt 1 output INT2 - Interrupt 2 output SCK - Serial clock MISO - Master input slave output MOSI - Master output slave input VCC-3.3 - +3.3V Voltage GND - Ground Figure 3: Accel SPI Board connection schematic MikroElektronika