2. Soldering the headers Before using your click board, make sure to solder the provided 1x8 male headers to both sides of the board. Two 1x8 male headers are included with the board in the package. 1 ETH click 2 3 1. Introduction 4. Board applications Due to zero hardware congfi uration, this board is the perfect solution for adding Turn the board upside down, so that Turn the board upward again. Make sure Ethernet feature to your devices. ETH click bottom side is facing you upwards. Place to align the headers so that they are is driven using SPI communication lines. shorter parts of the header pins in the perpendicular to the board, then solder the Target applications include VoIP, Industrial both soldering pad locations. pins carefully. Automation, Building Automation, Home Control, Security and Instrumentation, etc. ETH Click is an accessory board in mikroBus form factor. It features ENC28J60, a 28-pin, 3. Plugging the board in 10BASE-T stand alone Ethernet Controller click with an on-board MAC & PHY, 8K Bytes of Once you have soldered the headers your Bueff r RAM and SPI serial interface. Chip board is ready to be placed into desired BOARD supports programmable automatic retransmit mikroBUS socket. Make sure to align the www.mikroe.com on collision and automatic rejection of cut in the lower-right part of the board erroneous packets. Board contains standard with the markings on the silkscreen at the ETH click Manual RJ-45 connector, transmit, receive and power mikroBUS socket. If all the pins are aligned ver. 1.00 LEDs. On-board crystal oscillator ensures correctly, push the board all the way stable operation. Board is designed to use into the socket. 3.3V power supply only. 0 100000 0188976. Power supply - 3.3V only 5. ETH click Board Schematics Board is designed to use 3.3V power supply only. If you need to add ethernet feature to your 5V prototype or development board, we recommend you to use other boards such as the Serial Ethernet Accessory Board: