Standard 80-pin TQFP card with PIC18F8722 MCU v7 EasyPIC PROWhat s on Card PIC18F8722 microcontroller. Featuring nanoWatt technology, it has up to 1 10 MIPS operation, 128K bytes of linear program memory, 3936 bytes of linear data memory, and lot of internal modules. 10MHz crystal oscillator. We carefully chose the most convenient crystal 2 value that provides clock frequency which can be used directly, or with the PLL multipliers and dividers to create higher MCU clock value. VCAP jumper. Some PIC18FK and all PIC18FJ microcontrollers have cores that 3 work on 1.8V-2.5V voltage range, and peripherals that work with 3.3V and 2 5V voltages. Internally, those microcontrollers have power regulators which 6 adjust the core voltage levels. In order for those devices to have a stable operation of the core, manufacturer recommends that decoupling capacitive filters should be provided, and connected between specific microcontroller 1 pins designated with VCAP and GND. This MCU card provides a VCAP jumper 5 which is used for this purpose. Jumper is placed by default. USB communication lines. These two jumpers, when in USB position, connect 4 3 D+ and D- lines of the on-board USB connector with RF3 and RF4 microcontroller pins. Since PIC18F8722 doesn t support USB, jumpers are in I/O position. 4 VUSB line jumper. For PIC18F8xJ5x devices, this jumper should be connected 5 to VCC for enabling internal USB controller. Since PIC18F8722 doesn t support USB, this jumper is in I/O position. ENVREG selection jumper. PIC18FJ and PIC18FK microcontrollers are using 6 internal voltage regulator which is enabled by placing this jumper in VCC position. For PIC18F8722 this jumper is in I/O position. Figure 1: MCU card with PIC18F8722 v7 EasyPIC PRO page 2