TM-3000 and TM4000 Universal Press Safety Warnings and Information Read and understand all of the instructions and safety information in this manual before operating or servicing this tool. Keep this manual available when using this tool. Replacement manuals are available for download at no charge at www.molex.com. SAFETY ALERT SYMBOL This symbol is used to call your attention to hazards or unsafe practices which could result in an injury or property damage. The signal word, defined below, indicates the severity of the hazard. The message after the signal word provides information for preventing or avoiding the hazard. DANGER: Indicates an imminently hazardous situation which, if not avoided, could result in death or serious injury. DANGER WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. WARNING CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. CAUTION may also be used to alert against unsafe practices associated with events that could lead CAUTION to personal injury. WARNING WARNING Always wear proper eye protection when Heavy Object operating or servicing this equipment. To avoid muscle strain or back injury, use lifting aids and proper lifting techniques when moving this press. Failure to wear eye protection could result in Failure to observe these precautions may result in serious eye injury from flying debris. injury or property damage. WARNING WARNING Never install or service this machine while connected Never wear clothing or jewelery that is loose or to any electrical power source. that could potentially snag in the press and get Disconnect power by unplugging the press from its caught. power source. Failure to observe this warning could result in Failure to observe this warning could result in severe Injury or death. severe injury or death. WARNING WARNING Never operate, service, install, or adjust this Always hand cycle the applicator in the press to ensure machine without proper instruction and without the tooling is properly aligned. first reading and understanding the instructions in this manual and all applicable press and/or Failure to observe these precautions may result in wire processing machine manuals. injury or property damage. Doc. No: TM-638017299 Release Date: 06-06-05 UNCONTROLLED COPY Page 2 of 36 Revision: E Revision Date: 09-05-13