Auto Grip Pull Tester PT-1500 Auto Grip Pull Tester Operation Manual Order No. 63801-9100 Description Operation Maintenance Doc No: TM-638019100 Release Date: 08-10-09 UNCONTROLLED COPY Page 1 of 17 Revision: D Revision Date: 11-11-15 Auto Grip Pull Tester Safety Warnings and Information Read and understand all of the instructions and safety information in this manual before operating or servicing this tool. Keep this manual available when using this tool. Replacement manuals are available for download at no charge at www.molex.com. SAFETY ALERT SYMBOL This symbol is used to call your attention to hazards or unsafe practices which could result in an injury or property damage. The signal word, defined below, indicates the severity of the hazard. The message after the signal word provides information for preventing or avoiding the hazard. DANGER: Indicates an imminently hazardous situation which, if not avoided, could result in death or serious injury. DANGER WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. WARNING CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. CAUTION may also be used to alert against unsafe practices associated with events that could lead CAUTION to personal injury. WARNING WARNING Heavy Object Always wear proper eye protection when To avoid muscle strain or back injury, use lifting Operating or servicing this equipment. aids and proper lifting techniques when removing or replacing. Failure to wear eye protection could result Failure to observe these precautions may result in in serious eye injury from flying debris. injury or property damage. WARNING WARNING Do not use compressed air to clean this equipment. Never operate, service, install, or adjust this The forces created by compressed air can force machine without proper instruction and without debris into the tool. first reading and understanding the instructions in this manual and all applicable press and/or Failure to observe these precautions may wire processing machine manuals. result in injury or property damage WARNING Do not exceed the capacity of the display module, regardless of whether the display module (force gauge) is on or off, at 230 lbf (105 kgf), the display will flash Never exceed the maximum capacity of 440 LBF (200 kgf), or the load cell will be damaged. Avoid shock load. Failure to allow for sufficient overload capacity in the load, structure and mounting elements, may result in property damage, Serious injury, and even death Doc No: TM-638019100 Release Date: 08-10-09 UNCONTROLLED COPY Page 2 of 17 Revision: D Revision Date: 11-11-15