Reference Specification
Type KY
Safety Standard Certified Lead Type Disc Ceramic Capacitors for General Purpose
Product specifications in this catalog are as of May. 2018, and are subject to change or
obsolescence without notice.
Please consult the approval sheet before ordering.Please read rating and Cautions first.
Reference only
CAUTION
1. OPERATING VOLTAGE
When DC-rated capacitors are to be used in AC or ripple current circuits, be sure to maintain the
Vp-p value of the applied voltage or the Vo-p which contains DC bias within the rated voltage range.
When the voltage is started to apply to the circuit or it is stopped applying, the irregular voltage may
be generated for a transit period because of resonance or switching. Be sure to use a capacitor
within rated voltage containing these irregular voltage.
Pulse Pulse
Voltage DC Voltage DC+AC Voltage AC Voltage
Voltage(1) Voltage(2)
Positional
Vo-p Vp-p
Vo-p Vp-p
Vp-p
Measurement
2. OPERATING TEMPERATURE AND SELF-GENERATED HEAT
Keep the surface temperature of a capacitor below the upper limit of its rated operating temperature
range. Be sure to take into account the heat generated by the capacitor itself.
When the capacitor is used in a high-frequency current, pulse current or the like, it may have the self-
generated heat due to dielectric-loss. Applied voltage should be the load such as self-generated
heat is within 20 C on the condition of atmosphere temperature 25 C. When measuring, use a
thermocouple of small thermal capacity-K of 0.1mm and be in the condition where capacitor is not
affected by radiant heat of other components and wind of surroundings. Excessive heat may lead to
deterioration of the capacitors characteristics and reliability.(Never attempt to perform measurement
with the cooling fan running. Otherwise, accurate measurement cannot be ensured.)
3. TEST CONDITION FOR WITHSTANDING VOLTAGE
(1) TEST EQUIPMENT
Test equipment for AC withstanding voltage should be used with the performance of the wave similar
to 50/60 Hz sine wave.
If the distorted sine wave or over load exceeding the specified voltage value is applied, the defective
may be caused.
(2) VOLTAGE APPLIED METHOD
When the withstanding voltage is applied, capacitors lead or terminal should be firmly connected
to the out-put of the withstanding voltage test equipment, and then the voltage should be raised
from near zero to the test voltage.
If the test voltage without the raise from near zero voltage would be applied directly to capacitor, test
voltage should be applied with the *zero cross. At the end of the test time, the test voltage should be
reduced to near zero, and then capacitors lead or terminal should be taken off the out-put of the
withstanding voltage test equipment.
If the test voltage without the raise from near zero voltage would
voltage sine wave
be applied directly to capacitor, the surge voltage may arise,
and therefore, the defective may be caused.
0V
*ZERO CROSS is the point where voltage sine wave pass 0V.
zero cross
- See the right figure -
4. FAIL-SAFE
When capacitor would be broken, failure may result in a short circuit. Be sure to provide an
appropriate fail-safe function like a fuse on your product if failure would follow an electric shock,
fire or fume.
5. VIBRATION AND IMPACT
Do not expose a capacitor or its leads to excessive shock or vibration during use.
EGD08E
1 / 20