DMS-20-CP Murata

DMS-20-CP Panel Punch www.murata-ps.com Panel Cutout Punch and Instructions for Use with All DMS-20-P Series Meters* dDiscontinued ITEM QUANTlTY PART NO. DESCRIPTION A 1 DWG-DMS-20 Layout Drawing B 1 DMS-20P Punch C 1 DMS-20D Die D 1 DCS-6 Draw Screw E 2 DCS-7 Draw Screw F 2 SE-1 Eject Screw G 1 AW-D4 1/4 Hex Key H 1 AW-D7 5/32 Hex Key I 1 AW-E 9/64 Hex Key * Except model ACA-20PC-4-XXX-XX 100AMP AC ammeters. Re-use this container since the wrenches and screws are not standard. Keep all components together. Please note that this document is not an original the templates shown are not actual size and should be used for reference only. Important Note: This chassis cutout punch is not designed to cut through steel or copper panels. Aluminum and FR4 pc-board laminates up to 0.062 inches (15.7mm) thick can be punched SLOWLY. Most fiberglass and Plexiglas materials up to 0.125 inches (3.2mm) thick can also be accommodated. When using the punch on metals, applying a general-purpose cutting oil to the punch and screws is recommended. This cut out punch is intended to be used for prototype work only it is not recommended for production environments. Please see page 3 for additional instructions. For full details go to www.murata-ps.com/rohs www.murata-ps.com/support MPM DMS20-CP.D02 Page 1 of 3DMS-20-CP Panel Punch Panel Cutout Punch and Instructions for Use with All DMS-20-P Series Meters* ITEM A Template Detail & Hole Locations for DATEL PANEL PUNCH MODEL DMS-20-CP IMPORTANT The template shown below is NOT to scale do not use it for making hole and/or panel cutouts. www.murata-ps.com/support MPM DMS20-CP.D02 Page 2 of 3