GRM1555C1H4R7CZ01D Murata

Please read rating and CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc. Note C02E.pdf This catalog has only typical speci cations. Therefore, please approve our product speci cations or transact the approval sheet for product speci cations before ordering. Oct.1,2012 Please read rating and CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc. Note C02E.pdf This catalog has only typical speci cations. Therefore, please approve our product speci cations or transact the approval sheet for product speci cations before ordering. Oct.1,2012 Explanation of Symbols in This Catalog L x W dimension: products of 0.6 x 0.3 mm or less Voltage and temperature derating recommended product Ultra- Derating compact This product is suitable when a voltage continuously applied to a capacitor in an operating circuit, is used below (derated) the rated voltage of the capacitor. Low dissipation for high frequency HiQ This model guarantees the test conditions in the endurance test, By devising ceramic materials and electrode materials, at a rated voltage x 100% at the maximum operating temperature. low dissipation is achieved in frequency bands of VHF, A reliability assurance level equivalent to a common product UHF and microwave or beyond. can be secured, by using this product within the voltage and temperature derated conditions recommended in the figure below. Low inductance Low ESL This capacitor is designed so that s Recommended Conditions of the Derating Operating Voltage and Temperature the parasitic inductance component (ESL) that the capacitor has on the high frequency 120 side becomes lower. 100 125C Type Product suitable for acoustic noise reduction and low distortion Anti- 80 105C Type noise This product suppresses acoustic noise, which occurs when a ceramic capacitor is used, 85C Type 60 by devising the materials and configuration. 40 Product resistant to deflection cracking Deflecting crack 20 This capacitor is designed to prevent failures as much as possible by short mode caused by cracking 0 when there is board deflection. 025 50 75 100 125 150 Product Temperature (C) Product with solder cracking suppression Soldering crack This capacitor is configured with metal terminals and leads connected to the chip. The metal terminals and leads relieve the stress from expansion and contraction of the solder, to suppress solder cracking. s All the products in this catalog comply with EU RoHS. s EU RoHS isthe European Directive 2011/65/EU on the Restriction of the Use EU RoHS of Certain Hazardous Substances in Electrical and Electronic Equipment Compliant s For more details, please refer to our website Murata s Approach for EU RoHS (