Chip Monolithic
Ceramic Capacitors Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
!Note
This catalog has only typical speci cations. Therefore, please approve our product speci cations or transact the approval sheet for product speci cations before ordering.
Explanation of Symbols in This Catalog
L x W dimension: products of 0.6 x 0.3 mm or less Voltage and temperature derating recommended product
This product is suitable when a voltage continuously applied
to a capacitor in an operating circuit, is used below (derated)
the rated voltage of the capacitor.
Low dissipation for high frequency
By devising ceramic materials and electrode materials, This model guarantees the test conditions in the endurance test,
at a rated voltage x 100% at the maximum operating temperature.
low dissipation is achieved in frequency bands of VHF,
A reliability assurance level equivalent to a common product
UHF and microwave or beyond.
can be secured, by using this product within the voltage and
temperature derated conditions recommended in the figure below.
Low inductance
This capacitor is designed so that
s
Recommended Conditions of the Derating Operating Voltage and Temperature
the parasitic inductance component (ESL)
that the capacitor has on the high frequency
120
side becomes lower.
100
Product suitable for acoustic noise reduction and low distortion 125C Type
80
This product suppresses acoustic noise,
105C Type
which occurs when a ceramic capacitor is used,
85C Type
60
by devising the materials and configuration.
40
Product resistant to deflection cracking
This capacitor is designed to prevent failures as much
20
as possible by short mode caused by cracking
when there is board deflection. 0
025 50 75 100 125 150
Product Temperature (C)
Product with solder cracking suppression
This capacitor is configured with metal terminals
and leads connected to the chip.
The metal terminals and leads relieve the stress from expansion
and contraction of the solder, to suppress solder cracking.
s
All the products in this catalog comply with EU RoHS.
s
EU RoHS isthe European Directive 2011/65/EU on the Restriction of the Use
EU RoHS
of Certain Hazardous Substances in Electrical and Electronic Equipment
Compliant
s
For more details, please refer to our website 'Murata's Approach for EU RoHS'
(