HN-1010 HN-1510 RS-232 Serial Modbus Radio User Guide Revision History Revision Date Author Change Description 1 03/01/2008 F. Perkins Initial issue 2 01/22/2015 R. Willett Reformatted to comply with new Murata V.I. 3 01/13/2017 Updated Copyright R. Willett Copyright Murata Manufacturing Co., Ltd. All Rights Reserved. 2008 HN-1010/1510 01/13/17 www.murata.comImportant Regulatory Information RFM Product FCC ID: HSW-2410 IC 4492A-2410 Note: This unit has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their expense. FCC s MPE Requirements Information to user/installer regarding FCC s Maximum Permissible Exposure (MPE) limits. Notice to users/installers using the 24 dBi parabolic dish antenna in conjunction with all Murata RF products. FCC rules limit the use of this antenna, when connected to Murata RF products for point-to-point applications only. It is the responsibility of the installer to ensure that the system is prohibited from being used in point-to-multipoint applications, omni-directional applications, and applications where there are multiple co-located intentional radiators transmitting the same information. Any other mode of operation using this antenna is forbidden. Notice to users/installers using the following fixed antennas, with Murata RF products: The field strength radiated by any one of these antennas, when connected to Murata RF products, may exceed FCC mandated RF Andrews 24dBi parabolic dish exposure limits. FCC rules require Andrews 18dBi parabolic dish professional installation of these antennas in Cushcraft 15dBi Yagi, such a way that the general public will not be Mobile Mark 14dBi Corner Reflector, closer than 2 m from the radiating aperture of Mobile Mark 9dBi Corner Reflector any of these antennas. End users of these systems must also be informed that RF exposure limits may be exceeded if personnel come closer than 2 m to the apertures of any of these antennas. Notice to users/installers using the following mobile antennas, with Murata RF products: The field strength radiated by any one of these antennas, when connected to Murata RF products, may exceed FCC mandated RF Mobile Mark 12dBi omni-directional, exposure limits. FCC rules require professional Mobile Mark 9dBi omni-directional, installation of these antennas in such a way MaxRad 5dBi whip, that the general public will not be closer than Murata Patch antenna, 20 cm from the radiating aperture of any of Ace 2dBi dipole, these antennas. End users of these systems Mobile Mark 2dBi Stub must also be informed that RF exposure limits may be exceeded if personnel come closer than 20 cm to the apertures of any of these antennas. Copyright Murata Manufacturing Co., Ltd. All Rights Reserved. 2008 HN-1010/1510 01/13/17 www.murata.com