Multilayer Chip Inductors Series LL1005-FHL LL1608-FSL LL2012-FHL FEATURES Lineup of shape series expanded from 1005 size to 2012 10052012 size. Inductance range covering 0.2 nH~680 nH 0.2nH680nH High frequency characteristics: Can be used over the 400MHz10GHz range 400 MHz~10 GHz. 55C125C Lineup of a series that has an expanded working LL2012-FHL temperature range of 55C~+125C. (except LL2012- 100MHz FHL series) 800MHz Improved inductance value reliability: Lineup of a series LL1005-FHL, LL1608-FSL, LL2012-FHLseries whose inductance value is controlled by two frequencies RoHS (100 MHz and 800 MHz). RoHS compliant. PRECAUTIONS 1. Precaution for application 1. 1.1 The part must be pre-heated before soldering if reflow or 1.1 flow solder is applied. The difference between pre-heat temperature and soldering temperature must be within 150C. 150C 1.2 If a soldering iron is applied, the soldering process must 1.2 260C be completed within 3 seconds at the soldering 3 temperature lower than 260C. The tip of the soldering iron must not touch the terminal electrode in this process. 1.3 1 1.3 Soldering by using a soldering iron must be only once for 1 the same part. 1.4 1.4 PCB mounted this part must be handled with a care to minimize any physical stress to the part at the board assembly process. 1.5 To minimize the influence to the part, the thickness of 1.5 PCB, land dimension, and the amount of solder must be evaluated carefully by individual application. 1.6 CFC, triethance, and isopropil Alcohl used for the 1.6 washing process will not affect the part performance. 2. Precaution of storage Storage condition is critical to maintain an optimum soldering performance. 2. 2.1 Environmental requirements: Control ambient temperature at or under 40C and 70%RH. 2.1 Recommended use of the products within 6 months. 40C70RH 2.2 Influence of harmful gas: 6 Store the products in a place isolated from harmful gases like sulfur and chlorine. 2.2 Multilayer Chip Inductors PART NUMBERING SYSTEM REEL PACKAGING (1) Chip s placing (1) Chip Inductors are packaged into 8mm width, 4 or 2mm 8mm42mm pitch plastic or paper tape then enclosed by cover tape. (2) Carriage hole position Carriage hole position is right side of tape when sealing (2) tape is up side. Tape dimensions (Unit: mm)(mm) Reel dimensions (Unit: mm)(mm) Type A B C T T T Material (Tape) QTY (180) 1 2 3 LL2012 1.5 2.3 0.3 Max. 2.0 Plastic ~39nH:4000, 47nH~3000PCS/reel 4 LL1608 1.0 1.8 0.2 Max. 1.4 4000 PCS/reel LL1005 2 0.62 1.12 Max. 0.8 Paper 10,000PCS/reel Label: Customer s P/N, Q ty, TOKO P/N, TOKO, INC.