MHM501-00 Murata

MHM501 series / Ozonizer module / Key Features / Ideal for Sterilization and deodorization applications 1.0mg/h typ.(Duty:30%) Ozone amount : 1.0mg/h typ.(Duty:30%) Design that separates the high voltage power supply from the Ozone generator DC12V Compatible with DC12V input -1050 : -1050 Wide operating ambient temperature-1050Ozone generator part : -1050 Adoption of original Ozone generating device(Retain related patents) RoHS RoHS Compliant 1. / ORDERING GUIDE HV GND (g) (pcs) Model Number Length of HV wire(mm) Length of GND wire(mm) Weight(g) Quantity per box(pcs) X(mm) Y(mm) MHM501-00 11010 15010 39.1 200 2.(1) / INPUT CHARACTERISTIC Parameter Condition Min. Typ. Max. Units Vin(2) Input Voltage Operating Range DC 10.8 12.0 13.2 V Vin DC12V / Remote:L(on) - 200 380 mA Input Current DC12V / Remote:H(off) - 30 - mA DC12V / Remote:L(on) - 2.40 4.60 W Input Power DC12V / Remote:H(off) - 0.36 - W (3) - 0.5 - A Rush current (1) 1535 3080% 252 5010% 8 () Unless otherwise specified, tests and measurements will be made under the standard conditions (Temperature : 15 35,Relative humidity : 3080% ). If there may be any doubt on results, tests and measurements will be made under the following conditions, temperature : 252,Relative humidity : 5010%. If the test will be made under the special conditions, the measurement will be made leaving under the standard conditions for 8 hours or more. (2) On-Off 100 Input switching time should be less than 1milion times. MHM501 series / Ozonizer module (3) 13.2V 1ms The inrush current value is obtained under the following conditions. Input voltage: 13.2V Input voltage startup time: 1ms (slope increases monotonically) 3.4 / OUTPUT CHARACTERISTIC Parameter Condition Min. Typ. Max. Units 5 DC12V / Duty:100%6 5 11 20 ppm Initial value of Ozone density DC12V / Duty:30% - 3.5 - ppm 5 DC12V / Duty:100%6 1.4 3.0 5.7 mg/h Initial value of Ozone amount DC12V / Duty:30% - 1.0 - mg/h (4) 1535 3080% 252 5010% 8 () Unless otherwise specified, tests and measurements will be made under the standard conditions (Temperature : 1535,Relative humidity : 3080%). If there may be any doubt on results, tests and measurements will be made under the following conditions, temperature : 252,Relative humidity : 5010%. If the test will be made under the special conditions, the measurement will be made leaving under the standard conditions for 8 hours or more. (5) ( 6.7L) 3 EG-3000 / The device will be connected as the figure below and settle fan and Teflon tube for air sampling of ozone densimeter in box (approx. 6.7L). Under this condition, ozone density will be measure by the instrument after 3min. generation. Ozone monitor : EG-3000, Ebara Jitsugyo E 1 Fig.1 Ozone Measurement (6) On Duty This is reference data. Please use according to the maximum On Duty actually.