RFM products are now Murata products. SF2202E Surface Mount 3.0 x 3.0 x 1.3 mm Package Complies with Directive 2002/95/EC (RoHS) Pb 2017.5 MHz Absolute Maximum Ratings SAW Filter Rating Value Units Input Power Level 10 dBm DC Voltage on any Non-ground Terminal 3 V Operating Temperature Range -30 to +85 C Storage Temperature Range in Tape and Reel -40 to +85 C Solder Reflow Temperature, 10 seconds, 5 cycles maximum 260 C SM3030-6 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency F 2017.5 MHz C Insertion Loss, 2010 to 2025 MHz IL 2.9 4.0 dB Amplitude Ripple, 2010 to 2025 MHz 0.5 1.5 dB VSWR, 2010 to 2025 MHz 2.0 2.5 Group Delay Ripple, 2010 to 2025 MHz 4.0 25 ns Attenuation, Referenced to 0 dB D.C. to 1200 MHz 40 48 1200 to 1860 MHz 33 38 1920 to 1980 MHz 13 28 2045 to 2070 MHz 617 dB 2070 to 2085 MHz 26 39 2085 to 2800 MHz 30 35 2800 to 4000 MHz 22 30 Z Source Impedance 50 S Load Impedance Z 50 L Case Style SM3030-6 3.0 x 3.0 mm Nominal Footprint Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator 932, YWWS Standard Reel Quantity Reel Size 7 Inch 500 Pieces/Reel Reel Size 13 Inch 3000 Pieces/Reel CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. Notes: 1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance matching to 50 and measured with 50 network analyzer. 2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc. 3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external impedance matching design. See Application Note No. 42 for details. 4.LRI or after the part number indicateslow rate initial productio andEN or indicatesengineering prototypes 5. The design, manufacturing process, and specifications of this filter are subject to change. 6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design. 7. US and international patents may apply. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. 2010-2015 by Murata Electronics N.A., Inc. SF2202E (R) 9/2/15 Page 1 of 5 www.murata.comFrequency Characteristics 2010-2015 by Murata Electronics N.A., Inc. www.murata.com SF2202E (R) 9/2/15 Page 2 of 5