JOYSTICK ENCODER CJ25 FEATURES RoHS compliant O Multi-function device Joystick, optical encoder, and push switch functions in one package. O Suitable size for panels. Smooth operational feel. O Long life Joystick 500K cycles, encoder & switch 1M cycles O RoHS compliant APPLICATIONS Operation panels for Medical device Broadcast equipment Surveillance camera etc. PART NUMBER DESIGNATION CJ25 - 4 20 1 0 Series name Interface 0 Connector Joystick Push switch function 4 4 Directions 1 With push switch 8 8 Directions Encoder 20 20 Positions (5P/R) LIST OF PART NUMBERS Part number Joystick Encoder Push switch function Interface 4 directions CJ25-42010 20 Positions 5P/R With push switch Connector 8 directions CJ25-82010CJ25 JOYSTICK ENCODER STANDARD SPECIFICATIONS O Electrical characteristics O Mechanical characteristics Encoder Mounting Torque 1.17N m maximum (12kgf cm maximum) Input voltage DC5 V 5 % Actuator Strength 19.6N maximum (2kg maximum) Input current 20mA maximum at 5V Max. Shaft Pull-out Strength 98N maximum (10kg maximum) Output wave form Incremental signal (Square wave) Max. Shaft Push-out Strength 98N maximum (10kg maximum) Pulses Per Rotation 5P/R Encoder Maximum frequencies response 10Hz Click Torque 9.84.9mN m (10050gf cm) Output Open collector,Pull-up resistor 2.2K Clicks Per Rotation 20 Output Code 2-Bit, Channel A/B,Phase difference 90 Rotational Life 1 million cycles High 3.8V minimum Output Signal Low 0.4V maximum Joystick Output Sink Current 6mA minimum Angle of Throw All directions 92 Joystick Operating Force X,Y 1.470.74N (15075gf) Input current 5mA maximum at 5V Joystick Life 500,000 actuation each in directions (X, Y) Output Code 2-Bit (X,Y) Switch Neutral 2.50.5V Output Signal High 4.5V minimum Operating Force 3.431.47N (350150gf) Low 0.5V maximum Stroke 0.50.2mm Switch Switching Life 1 million cycles Rating DC5V, 10mA Contact Resistance 10 maximum O Environmental characteristics Switching 4ms make Contact Bouncing Non-switching 10ms break Operating Temp. Range 0C ~ + 50C Storage Temp. Range 20 ~ 80C RELIABILITY TEST Test item Test conditions Amplitude : 1.52mm or 98.1m/s2 (10G whichever is smaller. Vibration Power OFF 10 ~ 500Hz excursion 15 min/cycle, 8 cycles each for X, Z, directions. Shock Power OFF 3 times each in directions (X, Z) at 490m/s2 (50G), 11ms. Power OFF 80 C 96 h High temperature exposure Power ON 50 C 96 h (To be measured after leaving samples for 1 h at normal temperature and humidity after the test.) Power OFF 20 C 96 h Low temperature exposure 0 C 96 h Power ON C Relative humidity Humidity Power OFF (To be measured after wiping out moisture and leaving samples for 1 h at normal temperature and humidity after the test.) To be done 10 cycles with the following condition Thermal shock Power OFF (To be measured after leaving samples for 1 h at normal temperature and humidity after the test.) C C