FS22AAP NKK Switches

Series FS Miniature Slides for High Frequency General Specifications For high frequency (DC through 1GHz): Isolation 40dB minimum at 1GHz. Insertion loss 0.5dB maximum at 1GHz. Actual Size Impedance 75 ohms with Tall Actuator Innovative alternative to relay products Highly reliable, self-cleaning twin contact mechanism with gold plating Long total travel of .138 (3.5mm) for highly visible actuator position Distinct audible and tactile feedback during actuation Suited to high frequency applications (90MHz to 1GHz) such as CATV and communication equipment Distinctive Characteristics Electrical Capacity (Resistive Load) Logic Level: 0.4VA maximum 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. H RF Ratings Impedance: 75 ohms Insertion Loss: 0.5dB maximum 1GHz Isolation: 40dB minimum 1GHz Other Ratings Contact Resistance: 200 milliohms maximum Insulation Resistance: 250 megohms minimum 500V DC Dielectric Strength: 500V AC minimum for 1 minute minimum Mechanical Life: 1,000 operations minimum Electrical Life: 1,000 operations minimum Contact Timing: Nonshorting (break-before-make) Total Travel: .138 (3.5mm) Environmental Data Operating Temp Range: 30C through +85C (22F through +185F) Humidity: 90 ~ 95% humidity for 240 hours 40C (104F) Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 5 minutes 3 right angled directions for 2 hours 2 Shock: 50G (490m/s ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Installation Soldering Time & Temp: Wave Soldering: See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution. H14 www.nkkswitches.com Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers TogglesMiniature Slides for High Frequency Series FS TYPICAL SWITCH ORDERING EXAMPLE FS 2 2 A A P Pole Frequency Band Terminals 2 DPDT A DC through 1GHz P Straight PC Circuit Actuators 2 ON NONE ON A Short (.291 or 7.4mm) B Tall (.488 or 12.4mm) DESCRIPTION FOR TYPICAL ORDERING EXAMPLE FS22AAP H Short Actuator DPDT Frequency Band DC through 1GHz ON-NONE-ON Circuit Straight PC Terminals POLE & CIRCUIT Slide Position Connected Terminals Throw & Schematics Left Center Right Left Center Right Note: Terminal numbers are not actually on the switch. Pole Model 2 (COM) 5 DP FS22 ON NONE ON 2-1 5-4 NA 2-3 5-6 DPDT 13 4 6 www.nkkswitches.com H15 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles