GP0115ACCG30-R NKK Switches

CN-0310 New Product GP01 Series Ultra-Miniature Size Ideal for High Density Mounting Right Angle SMT Pushbuttons 2017-05-16Series GP01 Ultra-Miniature Right Angle SMT Pushbuttons General Specifications Electrical Capacity (Resistive Load) Logic Level: 0.4VA maximum 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A 20mV ~ 28V) Other Ratings Contact Resistance: 80 milliohms maximum Insulation Resistance: 500 megohms minimum 500V DC Dielectric Strength: 500V AC minimum for 1 minute minimum Mechanical Life: 40,000 operations minimum Electrical Life: 40,000 operations minimum Total Travel: .043 (1.1mm) Materials & Finishes Actuator/Plunger: Glass fiber reinforced polyamide Case: Glass fiber reinforced polyamide Moveable Contacts: Beryllium copper Base: Glass fiber reinforced polyamide Terminals: Brass with gold plating Environmental Data Operating Temperature Range: 40C through +85C (40F through +185F) Processing Soldering: Manual Soldering: 390C maximum for 4 seconds maximum Reflow Soldering: Preheat temperature: 180C ~ 200C Preheat time: 120 seconds Heating temperature: 230C Heating time: 60 seconds Peak temperature (surface): 250C. Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution. Note: After soldering, use caution to prevent mechanical stress on the terminal area and to avoid warpage of the circuit board. Distinctive Characteristics Ultra-miniature size allows high density mounting and utilizes reduced space for surface mounting. Greaseless condition contributes to resistance of harsh conditions, including wider operating temperatures. Cap and plunger are one unit, simplifying soldering and cleaning processes and eliminating need to remove and replace the cap. Plunger without cap is an alternate option. Heat resistant resin used for housing, base and plunger allows vapor phase and infrared convection reflow soldering. Highly reliable gold plated contacts provide stable contact performance throughout long term use. Actual Size J bend terminals lend to easy surface mounting and mechanical stability during soldering and simplified solder joint inspection. Remarkably precise coplanarity: all considered surfaces lying between two parallel planes are (0.1) a maximum distance apart of .0039 (0.1mm). Coplanarity .0039 2 www.nkkswitches.com