Series M Waterproof Miniature Toggles A General Specifications Electrical Capacity (Resistive Load) Power Level (silver): 6A 125V AC & 3A 250V AC 4A 30V DC for On-None-On 3A 30V DC for all other circuits Logic Level (gold): 0.4VA maximum 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A 20mV ~ 28V) Other Ratings Contact Resistance: 10 milliohms maximum for silver 20 milliohms maximum for gold Insulation Resistance: 1,000 megohms minimum 500V DC Dielectric Strength: 1,000V AC minimum between contacts for 1 minute minimum 1,500V AC minimum between contacts and case for 1 minute minimum Mechanical Life: 50,000 operations minimum Electrical Life: 50,000 operations minimum for silver at 3A 250V AC 25,000 operations minimum for silver at 6A 125V AC 50,000 operations minimum for gold Angle of Throw: 25 Environmental Data Operating Temp Range: 30C through +85C (22F through +185F) Sealing: Waterproofing, achieved with boot at base of lever plus o-rings inside and outside of bushing, meets IP68 of IEC60529 Standards (dust tight and protection against effects of temporary immersion). See further explanation on page A51. Processing Soldering: Manual Soldering for SIlver: ON-NONE-ON: See Profile B in Supplement section. ON-OFF-ON and (ON)-OFF-(ON): See Profile A in Supplement section. Manual Soldering for Gold, all circuits: See Profile A in Supplement section. Note: Lever must be in OFF (center) position while soldering. Distinctive Characteristics Inner o-ring and external rubber washer seal the switch to achieve IP68 of IEC60529 Standards (dust tight and water protected for temporary immersion). Waterproof boot at base of toggle further ensures protection against wet environments. Actuation provides smooth, sturdy tactile feel. Actual Size Polished, chrome-plated actuator paired with the waterproof boot not only delivers in terms of sleek design, but also functionality and reliability. Superb quality and construction design prohibit entry of harmful particles that may otherwise compromise lever operation. A48 www.nkkswitches.com 04/26/19 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers TogglesWaterproof Miniature Toggles Series M TYPICAL SWITCH ORDERING EXAMPLE A M20 1 2 WB G 01 Poles 1 SPDT Toggle with Large Contact Material & Ratings Terminals 2 DPDT Bushing 01 Solder Lug Silver Rated 6A 125V AC W .787 (20.0mm) Bat & 3A 250V AC with Large .472 Circuits WB Gold Rated 0.4VA max (12.0mm) Threaded G 28V AC/DC max 2 ON NONE ON Bushing with D Flat 3 ON OFF ON 8 (ON) OFF (ON) ( ) = Momentary DESCRIPTION FOR TYPICAL ORDERING EXAMPLE M2012WBG01 .787 (20.0mm) Bat Lever with Waterproof Boot .472 (12.0mm) Threaded SPDT Bushing with D Flat ON-NONE-ON Circuit Gold Contacts with 0.4VA Rating Solder Lug Terminals POLES & CIRCUITS Toggle Position Connected Terminals Throw & Schematics ( ) = Momentary Up Center Down Up Center Down Note: Terminal numbers are Pole Model not actually on the switch. Flat Flat M2012 ON NONE ON 2 (COM) SP M2013 ON OFF ON 2-3 OPEN 2-1 SPDT 3 1 M2018 (ON) OFF (ON) M2022 ON NONE ON 25(COM) DP M2023 ON OFF ON 2-3 5-6 OPEN 2-1 5-4 DPDT 3 1 6 4 M2028 (ON) OFF (ON) www.nkkswitches.com A49 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles