NP0115HG03LD NKK Switches

Series NP01 Subminiature Smooth Actuation Pushbuttons General Specifications Electrical Capacity (Resistive Load) Logic Level: 0.4VA maximum 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A 20mV ~ 28V) Other Ratings Contact Resistance: 50 milliohms maximum Insulation Resistance: 500 megohms minimum 250V DC D Dielectric Strength: 250V AC minimum between contacts for 1 minute minimum Mechanical Life: 500,000 operations minimum Electrical Life: 500,000 operations minimum Nominal Operating Force: Standard: 1.5N 0.5 Newtons High: 2.5N 0.8 Newtons Stroke: 1.5mm (.059) Materials & Finishes Actuator: Silicon rubber Case: Polycarbonate resin Base: Glass fiber reinforced polyamide resin Movable Contact: Silver over nickel with gold plating Stationary Contacts: Brass with gold plating Switch Terminals: Brass with gold plating Environmental Data Operating Temperature Range: 25C through +50C (13F through +122F) for Illuminated 25C through +70C (13F through +158F) for Nonilluminated Humidity: 90 ~ 95% humidity for 96 hours 40C (104F) Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute 3 right angled directions for 2 hours 2 Shock: 50G (490m/s ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Installation Cap Installation Force: 5.0N maximum downward force on actuator PCB Processing Soldering: Wave Soldering: 270C maximum 6 seconds maximum Manual Soldering: 390C maximum 4 seconds maximum Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution. Standards & Certifications The NP01 Series pushbuttons have not been tested for UL recognition or CSA certification. These switches are designed for use in a low-voltage, low-current, logic-level circuit. When used as intended in a logic-level circuit, the results do not produce hazardous energy. D74 www.nkkswitches.com 7 / 1 9 /17 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers TogglesSubminiature Smooth Actuation Pushbuttons Series NP01 Distinctive Characteristics Soft touch actuation achieved by mechanical silicon rubber structure. Distinct, long stroke of 1.5mm (.059). Entire cap is fully illuminated with single or bicolor LED. D Compact design with dimension of 12.5mm (.492) from PC board to top of cap. Alternating legend options with bicolor LED. Available in both high (2.5N) or standard (1.5N) operating force. Gold plated contacts provide high reliability. Crimped terminals ensure secure PC mounting and prevent dislodging during soldering. Molded-in terminals prevent entry of flux, solvents, and other contaminants. Actual Size www.nkkswitches.com D75 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles