Plug-in units type 2 with extraction handle front panel shielded 3 U Article number: 20848-490 For 6 U, the board location can be moved 1 HP to the right by swapping the upper and lower printed board brackets. This creates space for SMD components on the left-hand side (solder side). kit Delivery quantity: Item Qty Description 1 1 Extraction handle, PPE, grey, at bottom 1a - Extraction handle, PPE, grey, at top Identification plate, 1.5 mm aluminium, anodised, cut edges 2 1 clean 3 1 Pivot bush, brass 4 1 Printed board bracket, diecast zinc, at bottom 4a - Printed board bracket, diecast zinc, at top 5 1 Printed board bracket, diecast zinc 6 1 U-Front panel for handle, front anodised, rear chromated 7 2 Alignment pin, pressed in, stainless steel 8 2 Sleeve, PA, grey, up to 7 HP front panel width 8 4 Sleeve, PA, grey, up to 8 HP front panel width Collar screw, cross recess/slot, nickel-plated steel, M2.5 12.3, 9 2 up to 8 HP front panel width Collar screw, cross recess/slot, nickel-plated steel, M2.5 12.3, 9 4 from 8 HP front panel width 11 1 Raised countersunk head screw, M2.5 8 12 1 EMC textile seal 13 2 Washer, A2.7 Pozidrive flathead screw with cross recess, nickel-plated steel, 14 2 M2.5 10 Technical data: Width Height 10 HP 3 U