MC33932VW NXP

MC33932 5.0 A throttle control H-bridge Rev. 6.0 10 September 2018 Data sheet: technical data 1 General description The 33932 is a monolithic H-bridge power IC in a robust thermally enhanced package. The 33932 has two independent monolithic H-bridge power ICs in the same package. They are designed primarily for automotive electronic throttle control, but are applicable to any low voltage DC servo motor control application within the current and voltage limits stated in this specification. It meets the stringent requirements of automotive applications and is fully AEC-Q100 grade 1 qualified. Each H-bridge in the 33932 is able to control inductive loads with currents up to 5.0 A peak. RMS current capability is subject to the degree of heat sinking provided to the device package. Internal peak-current limiting (regulation) is activated at load currents above 6.5 A 1.5 A. Output loads can be pulse-width modulated at frequencies up to 11 kHz. A load current feedback feature provides a proportional (0.24 % of the load current) current output suitable for monitoring by a microcontrollers A/D input. A status flag output reports undervoltage, overcurrent and overtemperature fault conditions. Two independent inputs provide polarity control of two half-bridge totem pole outputs. Two independent disable inputs are provided to force the H-bridge outputs to 3-state (high-impedance OFF state). V V PWR DD 33932 SFA VPWRA FBA CCPA OUT1 MOTOR IN1 OUT2 IN2 V PWR PGNDA D1 EN/D2 AGNDA MCU IN3 IN4 D3 VPWRB EN/D4 CCPB FBB OUT3 MOTOR SFB OUT4 V DD PGNDB AGNDB Figure 1.Simplified application diagram 2 Features and benefits 8.0 to 28 V continuous operation (transient operation from 5.0 to 40 V) 235 m maximum R T = 150 C (each H-bridge MOSFET) DS(on) J 3.0 V and 5.0 V TTL / CMOS logic compatible inputs Output short-circuit protection (short to VPWR or GND) Overcurrent limiting (regulation) via internal constant-off-time PWM Temperature dependent current limit threshold reduction All inputs have an internal source/sink to define the default (floating input) stateNXP Semiconductors MC33932 5.0 A throttle control H-bridge Sleep mode with current draw < 50 A (each half with inputs floating or set to match default logic states) AEC-Q100 grade 1 qualified 3 Applications Electronic throttle control (ETC) Exhaust gas recirculation (EGR) Turbo flap control Industrial and medical pumps Stepper motor control Dual motor drive 4 Ordering information Table 1.Ordering information 1 Type number Package Name Description Operating Version temperature MC33932VW HSOP44 HSOP44, plastic, thermal enhanced small SOT1305-2 outline package 44 terminals 0.65 mm pitch 15.9 mm x 11 mm x 3 mm body T = 40 C to 125 C A MC33932EK HSOP54 HSOP54, plastic, heat sink small outline SOT1747-4 package 54 terminals 0.65 mm pitch 17.9 mm x 7.5 mm x 2.65 mm body 1 To order parts in tape and reel, add the R2 suffix to the part number. MC33932 All information provided in this document is subject to legal disclaimers. NXP B.V. 2018. All rights reserved. Data sheet: technical data Rev. 6.0 10 September 2018 2 / 32