MPC745BPX300LE NXP

Free Freescale Semiconductor, Inc. MPC755 D PNS 010410 Freescale Part Numbers Affected: XPC755BRX300LD XPC745BPX300LD XPC755BRX350LD XPC745BPX350LD XPC755BRX400LD Application-Specic Information XPC755BPX300LD XPC755BPX350LD XPC755BPX400LD MPC755 Part Number Specication This document describes part number specic changes to recommended operating conditions and revised electrical specications, as applicable, from those described in the general MPC755 Hardware Specications. MPC755 Hardware Specications (order : Specications provided in this Part Number Specication supersede those in the MPC755EC/D) for these part numbers only specications not addressed herein are unchanged. Because this document is frequently updated, refer to the website at Freescale Semiconductor, Inc. 1.3 General Parameters The following general parameters apply to all part numbers described herein: Core power supply: 2.0 V 100 mV dc (nominal see Table 3 for recommended operating conditions) I/O power supply 1.8 V 100 mV dc (processor bus interface only not supported on L2 interface) or 2.0 V 100 mV dc (processor bus interface only not supported on L2 interface) or 3.3 V 165 mV dc (input thresholds are conguration pin selectable) Note that part revisions prior to Rev 2.8 (Rev E) do not support core voltages down to 1.8 V. 1.4.1 DC Electrical Characteristics All part numbers affected by this specication support 3.3V and 1.8V/2.0V I/O voltages but do not support 2.5V I/O voltages. Table 2 describes the input threshold voltage settings. These settings apply to all device revisions prior to Rev. 2.8 (Rev E), including all part numbers described herein. Note that the MPC745 does not provide an L2 interface. Table 2 Input Threshold Voltage Settings Processor Bus Interface L2 Bus BVSEL Signal L2VSEL Signal Voltage Interface Voltage 0 0 1.8V or 2.0V 1.8V or 2.0V 0 1 1.8V or 2.0V 3.3V 1 0 3.3V 1.8V or 2.0V 1 1 3.3V 3.3V Caution: The input threshold selection must agree with the OVdd/L2OVdd voltages supplied. Table 3 provides the recommended operating conditions for all device revisions prior to Rev. 2.8 (Rev E), including all part numbers described herein. Table 3 Recommended Operating Conditions Characteristic Symbol Recommended Value Unit Core supply voltage Vdd 2.0 100 mV V PLL supply voltage AVdd 2.0 100 mV V L2 DLL supply voltage L2AVdd 2.0 100 mV V Processor bus supply voltage BVSEL = 0 OVdd 1.8 100 mV or V 2.0 100 mV BVSEL = 1 OVdd 3.3 165 mV V L2 bus supply voltage L2VSEL = 0 L2OVdd 1.8 100 mV or V 2.0 100 mV L2VSEL = 1 L2OVdd 3.3 165 mV V Note: These are the recommended and tested operating conditions. Proper device operation outside of these conditions is not guaranteed. 2 MPC755 Part Number Specifications PRELIMINARYSUBJECT TO CHANGE WITHOUT NOTICE For More Information On This Product, Go to: www.freescale.com Freescale Semiconductor, Inc...