NX5P1000UKZ NXP

NX5P1000 Logic controlled high-side power switch Rev. 1 29 April 2013 Product data sheet 1. General description The NX5P1000 is an advanced power switch and ESD- protection device for USB OTG applications. The device includes under voltage and over voltage lockout, over-current, over-temperature, reverse bias and in-rush current protection circuits. These circuits are designed to isolate a VBUS OTG voltage source automatically from a VBUS interface pin when a fault condition occurs. The device features two power switch terminals, one input (VINT) and one output (VBUS). It has a current limit input (ILIM) for defining the over-current and in-rush current limit. A voltage detect output (VDET) is used to determine when VINT is in the correct voltage range. An open-drain fault output (FAULT) indicates when a fault condition has occurred and an enable input (EN) controls the state of the switch. When EN is set LOW the device enters a low-power mode, disabling all protection circuits except the undervoltage lockout. The low-power mode can be entered at anytime unless the over temperature protection circuit has been triggered. Designed for operation from 3 V to 5.5 V, it is used in power domain isolation applications to protect from out of range operation. The enable input includes integrated logic level translation making the device compatible with lower voltage processors and controllers. 2. Features and benefits Wide supply voltage range from 3 V to 5.5 V 30 V tolerant on VBUS I maximum 1 A continuous current SW Very low ON resistance: 100 m (maximum) at a supply voltage of 4.0 V Low-power mode (ground current 20 A typical) 1.8 V control logic Soft start turn-on slew rate Protection circuitry Over-temperature protection Over-current protection with low current output mode Reverse bias current/Back drive protection Overvoltage lockout Undervoltage lockout Analog voltage limited VBUS monitor path ESD protection: HBM ANSI/ESDA/JEDEC JS-001 Class 2 exceeds 2 kV IEC61000-4-2 contact discharge exceeds 8 kV for pins VBUS, D , D+ and ID Specified from 40 C to +85 CNX5P1000 NXP Semiconductors Logic controlled high-side power switch 3. Applications USB OTG applications 4. Ordering information Table 1. Ordering information Type number Package Temperature range Name Description Version NX5P1000UK 40 C to +85 C WLCSP12 wafer level chip-scale package 12 bumps NX5P1000 1.36 1.66 0.51 mm, 0.4 mm pitch (Backside Coating included) 5. Marking Table 2. Marking codes Type number Marking code NX5P1000UK NX5P1 6. Functional diagram Fig 1. Logic symbol NX5P1000 All information provided in this document is subject to legal disclaimers. NXP B.V. 2013. All rights reserved. Product data sheet Rev. 1 29 April 2013 2 of 19