PN7150 High performance NFC controller with integrated firmware, supporting all NFC Forum modes Rev. 4.0 25 June 2020 Product data sheet 317440 COMPANY PUBLIC 1 Introduction This document describes the functionality and electrical specification of the NFC Controller PN7150. Additional documents describing the product functionality further are available for design- in support. Refer to the references listed in this document to get access to the full documentation provided by NXP.NXP Semiconductors PN7150 High performance NFC controller with integrated firmware, supporting all NFC Forum modes 2 General description Plugn play and high-performance full NFC solution PN7150 is a full NFC controller solution with integrated firmware and NCI interface designed for contactless communication at 13.56 MHz. It is compatible with NFC forum requirements. PN7150 is designed based on learnings from previous NXP NFC device generation. It is the ideal solution for rapidly integrating NFC technology in any application, especially those running O/S environment like Linux and Android, reducing Bill of Material (BOM) size and cost, thanks to: Full NFC forum compliancy (see 1 ) with small form factor antenna Embedded NFC firmware providing all NFC protocols as pre-integrated feature 2 Direct connection to the main host or microcontroller, by I C-bus physical and NCI protocol Ultra-low power consumption in polling loop mode Highly efficient integrated power management unit (PMU) allowing direct supply from a battery PN7150 embeds a new generation RF contactless front-end supporting various transmission modes according to NFCIP-1 and NFCIP-2, ISO/IEC 14443, ISO/IEC 15693, MIFARE Classic IC-based card and FeliCa card specifications. It embeds an Arm Cortex-M0 microcontroller core loaded with the integrated firmware supporting the NCI 1.0 host communication. It also allows to provide a higher output power by supplying the transmitter output stage from 3.0 V to 4.75 V. The contactless front-end design brings a major performance step-up with on one hand a higher sensitivity and on the other hand the capability to work in active load modulation communication enabling the support of small antenna form factor. Supported transmission modes are listed in Figure 1. For contactless card functionality, the PN7150 can act autonomously if previously configured by the host in such a manner. PN7150 integrated firmware provides an easy integration and validation cycle as all the NFC real-time constraints, protocols and device discovery (polling loop) are being taken care internally. In few NCI commands, host SW can configure the PN7150 to notify for card or peer detection and start communicating with them. NFC FORUM READER CARD NFC-IP MODES (PCD - VCD) (PICC) READER FOR NFC FORUM ISO/IEC 14443 A T4T - ISO/IEC 14443 A Tag Types 1 TO 5 ISO/IEC 14443 B T4T - ISO/IEC 14443 B P2P ACTIVE 106 TO 424 kbps ISO/IEC 15693 NFC FORUM T3T INITIATOR AND TARGET MIFARE Classic 1K/4K P2P PASSIVE 106 TO 424 kbps MIFARE DESFire INITIATOR AND TARGET (1) Sony FeliCa aaa-023871 Figure 1.PN7150 transmission modes 1. According to ISO/IEC 18092 (Ecma 340) standard. PN7150 All information provided in this document is subject to legal disclaimers. NXP B.V. 2020. All rights reserved. Product data sheet Rev. 4.0 25 June 2020 COMPANY PUBLIC 317440 2 / 66