TJA1083GTT/0Z NXP

TJA1083G FlexRay node transceiver Rev. 1 18 January 2018 Product data sheet 1. General description The TJA1083G FlexRay node transceiver is compliant with the FlexRay Electrical Physical Layer specification ISO 17458-4:2013 (see Ref. 1 and Ref. 2). It is primarily intended for communication systems operating at between 2.5 Mbit/s and 10 Mbit/s, and provides an advanced interface between the protocol controller and the physical bus in a FlexRay network. The TJA1083G offers an optimized solution for Electronic Control Unit (ECU) applications that do not need enhanced power management and are typically switched by the ignition or activated by a dedicated wake-up line. The TJA1083G provides a differential transmit capability to the network and a differential receive capability to the FlexRay controller. It offers excellent ElectroMagnetic Compatibility (EMC) performance as well as high ElectroStatic Discharge (ESD) protection. The TJA1083G actively monitors system performance using dedicated error and status information (readable via SPI), as well as internal voltage and temperature monitoring. The TJA1083G is fully functionally and pin compatible with the TJA1083 (see Ref. 3). 2. Features and benefits 2.1 Optimized for time triggered communication systems Compliant with ISO 17458-4:2013 (see Ref. 2) Automotive product qualification in accordance with AEC-Q100 Data transfer rates from 2.5 Mbit/s to 10 Mbit/s Supports 60 ns minimum bit time at 400 mV differential input voltage Very low ElectroMagnetic Emission (EME) to support unshielded cable, meeting the latest industry standards Differential receiver with high common-mode range for excellent ElectroMagnetic Immunity (EMI), meeting the latest industry standards Auto I/O level adaptation to host controller supply voltage V IO Can be used in 14 V, 24 V and 48 V powered systems Instant transmitter shut-down interface (BGE pin) 2.2 Low-power management Very low current consumption in Standby mode Remote wake-up via a wake-up pattern or dedicated FlexRay data frames on the bus linesTJA1083G NXP Semiconductors FlexRay node transceiver 2.3 Diagnosis and robustness Enhanced supply voltage monitoring for V and V CC IO Two error diagnosis modes: Status register readout via the Serial Peripheral Interface (SPI) Simple error indication via pin ERRN Overtemperature detection Short-circuit detection on bus lines Power-on flag Clamping diagnosis for pins TXEN and BGE Bus pins protected against 6 kV ESD pulses according to IEC61000-4-2 and 8 kV according to HBM Bus pins protected against transients in automotive environment (according to ISO 7637 class C) Bus pins short-circuit proof to battery voltage (14 V, 24 V and 48 V) and ground Maximum differential voltage between pins BP or BM and any other pin of 60 V Bus lines remain passive when the transceiver is not powered No reverse currents from the digital input pins to V or V when the transceiver is not IO CC powered 2.4 Functional classes according to FlexRay Electrical Physical Layer specification V3.0.1 Bus driver - bus guardian control interface Bus driver - logic level adaptation Bus driver - remote wake-up 3. Ordering information Table 1. Ordering information Type number Package Name Description Version TJA1083GTT TSSOP14 plastic thin shrink small outline package 14 leads body width 4.4 mm SOT402-1 TJA1083G All information provided in this document is subject to legal disclaimers. NXP B.V. 2018. All rights reserved. Product data sheet Rev. 1 18 January 2018 2 of 41