LPC-H1114 development board Users Manual All boards produced by Olimex are ROHS compliant Revision B, June 2012 Copyright(c) 2011, OLIMEX Ltd, All rights reserved Page 1 INTRODUCTION LPC-P1114 is development board with LPC1114FBD48 ARM Cortex-M0 based microcontroller for embedded applications from NXP. LPC-P1114 featuring a high level of integration and low power consumption. This microcontroller sup- ports various interfaces such as one Fast-mode Plus I2C-bus interface, one RS- 485/EIA-485 UART, two SSP interfaces, four general purpose timers, a 10-bit ADC. On the board are available Debug Interface and extension headers for all microcon- troller ports. BOARD FEATURES MCU: LPC1114FBD48/301/302 Cortex-M0, up to 50 Mhz, 32 kB Flash, 2 8kB SRAM, UART RS-485, two SSP, I C/Fast+, ADC Debug interface SWD (Serial Wire Debug) Extension connectors FR-4, 1.5 mm, soldermask, component print Dimensions:38.00x38.00mm (1.50 x 1.50 ) ELECTROSTATIC WARNING The LPC-H1114 board is shipped in protective anti-static packaging. The board must not be subject to high electrostatic potentials. General practice for working with static sensitive devices should be applied when working with this board. BOARD USE REQUIREMENTS Cables: The cable you will need depends on the programmer/debugger you use. If you use ARM-JTAG-EW, you will need USB A-B cable. Hardware: Programmer/Debugger ARM-JTAG-EW, which works with IAR for ARM up to version 6.20 or other compatible programming/debugging tool. ARM-USB-OCD, ARM-USB-OCD-H, ARM-USB-TINY, ARM-USB-TINY-H - JTAGs + ARM-JTAG-SWD adapter can be used with Rowley Crossworks. PROCESSOR FEATURES LPC-P1114 board use ARM Cortex-M0 microcontroller LPC1114FBD48/301/302 from NXP Semiconductors with these features: ARM Cortex-M0 processor, running at frequencies of up to 50 MHz. ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC). 32 kB on-chip flash programming memory. 8 kB SRAM. Page 2