PYC-P2 Omron

Common Sockets CSM common sockets DS E 3 15 A Wide Variety of Square and Round Sockets in Front-mounting and Back-mounting Models Models available with finger protection. Hold-down Clips and Short Bars for PYFZ/PYF Sockets are also available. New screwless models available. For the most recent information on models that have been certified for safety standards, refer to your OMRON website. Ordering Information Square Sockets Model P2R (back-mounting), pages 11 and 12 P7TF (front- P2RF (front-mounting), page 8 mounting), Number page 12 Solder terminals PCB terminals of pins * P2RF-05 P2RFZ-05-E P2RF-05-E P2R-05A P2R-05P P2R-057P P7TF-05 Approx. 27 g Approx. 30 g Approx. 38 g Approx. 5 g Approx. 5 g Approx. 5.5 g Approx. 28 g 5 pins * P2RF-08 P2RFZ-08-E P2RF-08-E P2R-08A P2R-08P P2R-087P --- Approx. 33 g Approx. 38 g Approx. 38 g Approx. 5 g Approx. 5 g Approx. 5.5 g 8 pins Note: 1. The structure of -E models provides finger protection. Round terminals cannot be used. Use forked crimp terminals. 2. To remove the Relay, pull the lever on the Socket with your fingers supporting the lever and the opposite side of the Relay case, and jiggle the Relay. * Use a 1 Phillips screwdriver to tighten the screws on this Socket. 1Common Sockets Model PY (back-mounting), pages 16 to 14 PYF (front-mounting), pages 13 to 14 Number Solder terminals Wrapping terminals PCB terminals of pins *2 PYF08A PYF08M PY08 PY08-Y1 PY08QN PY08QN-Y1 PY08-02 Approx. 32 g Approx. 26 g Approx. 8 g PY08-Y3 Approx. 12 g PY08QN2-Y1 Approx. 7.2 g PY08QN2 *1 PYFZ-08 PYF08A-E Approx. 8 pins *1 PYFZ-08-E Approx. 1 *2 PY11QN-Y1 PYF11A PY11 PY11-Y1 PY11QN PY11-02 PY11QN2-Y1 Approx. 43 g Approx. 9 g PY11QN2 11 pins *2 PY14QN-Y1 PYF14A PYFZ-14 PY14 PY14-Y1 PY14QN PY14-02 PY14QN2-Y1 Approx. 49 g Approx. 50 g Approx. 10 g PY14-Y3 Approx. 14 g PY14QN-Y3 PY14QN2 PY14QN2-Y3 14 pins *1 *1 PYFZ-14-E PYF14A-E Approx. 50 g Note: The structure of -E models provides finger protection. Round terminals cannot be used. Use forked crimp terminals. *1. Use a 1 Phillips screwdriver to tighten the screws on this Socket. *2. The structure does not resist flux. Manual soldering is recommended for this product. 2