Xeon 5 Power LED Xeon 5 Power LED OSXXXDE5E1E VER C.3 3.6 Features Highest Luminous Flux Super Energy Efficiency Long Lifetime Operation Superior ESD protection Superior UV Resistance BackView Applications Read lights (car, bus, aircraft) Portable (flashlight, bicycle) Cathode Anode Bollards / Security / Garden Traffic signaling / Beacons ESD Protection Diode In door / Out door Commercial lights Unit:mm Tolerance:0.30mm Automotive Ext Absolute Maximum Rating ((((TTTTaaaa====22225555)))) Directivity Value Unit 0 Item Symbol R/Y W/B/PG DC Forward Current I 1400 1600 mA F Pulse Forward Current* IFP 1800 2000 mA Reverse Voltage VR 5 5 V Power Dissipation PD 6300 5600 mW 0 Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol 260/5sec *Pulse width Max.10ms Duty ratio max 1/10 Electrical -Optical Characteristics ((TTaa==2255)) ((TTaa==2255)) 21/2 V (V) I (A) CCT Luminous Flux D(nm) F R v (lm) (deg) (K) Part Number Color Min. Typ. Max. Max. Typ Min. Typ. Max. Min. Typ. Max. I =1400mA V =5V I =1400mA F R F 3.3 3.5 4.5 6500 300 320 - OSW4XDE5E1E Pure White W4 10 Typ. 6500K 300 OSM7XDE5E1E Warm White M7 3.3 3.5 4.5 10 4000 320 - Typ.4000K OSM5XDE5E1E Warm White M5 3.3 3.5 4.5 10 3000 280 300 - Typ.3000K OSB4XDE5E1E Blue B4 3.3 3.5 4.5 10 50 70 455 460 465 140 OSG5XDE5E1E Pure Green G5 3.3 3.5 4.5 10 280 300 520 525 530 OSR5XDE5E1E Red R5 2.3 2.5 3.5 10 140 160 620 625 630 OSY5XDE5E1E Yellow Y5 2.3 2.5 3.5 10 - 140 160 - 585 590 595 Note: Dont drive at rated current more than 5s without heat sink for Xeon 5 emitter series. LED & Application Technologies Xeon 5 Power LED Xeon 5 Power LED OSXXXDE5E1E VER C.3 Handling of Silicone Lens LEDs Notes for handling of silicone lens LEDs Please do not use a force of over 3kgf impact or pressure on the silicone lens, otherwise it will cause a catastrophic failure. The LEDs should only be picked up by making contact with the sides of the LED body. Avoid touching the silicone lens especially by sharp tools such as Tweezers. Avoid leaving fingerprints on the silicone lens. Please store the LEDs away from dusty areas or seal the product against dust. When populating boards in SMT production, there are basically no restrictions regarding the form of the pick and place nozzle, except that mechanical pressure on the silicone lens must be prevented. Please do not mold over the silicone lens with another resin. (epoxy, urethane, etc) LED & Application Technologies