PML065-480 Phihong

PML065 WWW.PHIHONG.COM 65W 2x4 Open Frame Medical Power Supply Series Features 2x4 Footprint Low Cost Low Profile Class B EMI OVP, SCP and OCP Meets DOE Level VI < 100A Touch Current Class II Design MOPP x 2 Applications Diagnostic Equipment Medical Devices Meets IEC/EN/ANSI/AAMI ES 60601- 1 (ED 3.1) Mechanical Characteristics Length: 101.6mm (4in) Height: 28.1mm (1.12in) Width: 50.8mm (2in) Weight: 141g (4.97oz) Output Specifications 1 Output Max Output Ripple & Noise Model Regulation Voltage Current Power P-P(max) PML065-120 12V 5A 60W 5% 150mV PML065-150 15V 4.34A 65W 5% 150mV PML065-180 18V 3.62A 65W 5% 180mV PML065-190 19V 3.43A 65W 5% 190mV PML065-240 24V 2.71A 65W 5% 240mV PML065-480 48V 1.36A 65W 5% 480mV Notes: 1. 20 MHz bandwidth frequency oscilloscope and add a 0.1 F multilayer cap.and a Low ESR electrolytic cap. (10 F ) at output connector terminals. (at nominal line voltage, full load) Phihong is not responsible for any errors and reserves the right to make changes without notice. Please visit our website at www.phihong.com/ for the most up-to-date specifications and contact information. Revised 3/5/2019 PML065 Characteristics WWW.PHIHONG.COM INPUT: ENVIRONMENTAL: AC Input Voltage Range Temperature 100 to 240VAC Operation 0 to +50C Non-operation -20 to +80C Humidity AC Input Current Operating 20% to 80% 1.6A max Storage 10% to 90% Leakage Current <0.1mA EMC Complies with FCC Part 18 Class B AC Input Frequency Complies with EN55011 Class B 50-60Hz Dielectric Strength Cut off current 10mA AC Inrush Current Primary to secondary 4000VAC for 1min 80A max/230VAC (cold start at 25C, full load) Insulation Resistance Primary to secondary 10M ohm for 500VDC Input Power Saving 0.21W at 230VAC, no load Input Connector CN1 2PIN WAFER (Pitch=7.92mm) OUTPUT: Efficiency Output Connector 88% average at 115VAC & 230VAC CN2 4PIN WAFER (Pitch=3.96mm) Over Voltage Protection V out 150% Short Circuit Protection Auto-recovery after short-circuit fault being removed Over Current Protection I out 180%