WWW.PHIHONG.COM 33W, IEEE802.3at Single Port PoE Active Injector Features IEEE802.3at Complaint Full Over-Voltage and Over-Current Protection DOE VI Efficiency Non-Vented Case Australian GEMS Registered 1 Year Warranty Compact Size Limited Power Source Three Wire Input Applications IP Telephones Security Cameras Wireless Access Points IP Print Servers Bluetooth Access Points WiMAX Access Points Safety Approvals cUL/UL 62368-1 CE cUL/UL, 60950-1 IEC 62368-1 UKCA RCM 62368-1 BSMI KC+KCC CCC EAC PSB BSI C Mechanical Characteristics Length: 140.1mm (5.51in.) Height: 30mm (1.18in.) Width: 45.5mm (1.79in.) Weight: 0.2kg (7.05oz) Output Specifications 1 Data Output DC Output Load Regulation 2 Model Ripple Speed Power Voltage Min. Max. Line Load POEA33U-1ATE-R 1G 33W 55V 10mA 600mA 53-56V 200mV Notes: 1. Voltage measured within 5cm of the output RJ45 connector on data pairs 3,6(+) and 1,2(-) 2. Measured with by-pass capacitors 0.1uf/10uf at output connector terminal and oscilloscope set at 20Mhz. 20 minutes warm-up required when operating at negative temperature. Phihong is not responsible for any error and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revision 10/25/2021 1 POEA33U-1AT-R Characteristics WWW.PHIHONG.COM INPUT: Immunities AC Input Voltage Range IEC61000-4-2 (ESD) 4KV Contact/8KV Air 90 to 264VAC IEC61000-4-3 (RS) 3V/m IEC61000-4-4(EFT) 1KV Input, 0.5KV Output AC Input Current IEC61000-4-5 (Surge) 1KV L-L, 2KV L-PE 0.8A (RMS) max IEC61000-4-6 (CS) 3V IEC61000-4-11 (Dips) Class 3 AC Input Frequency IEC61000-3-2 (Harmonic) Class D 47Hz to 63Hz Isolation (HI-POT) Leakage Current 4242VDC for 1 minute, 10mA 3.5mA max 254V, 50Hz Insulation Resistance Max In-rush Current Primary to secondary:>10M Ohm 500VDC 70A max at 240VAC and max load (Cold Start at ambient 25C) MTBF 150,000 Hours Min Max Load 115VAC 25C OUTPUT: Output Power 33W -10C to + 40C, de-rated to 15W at FEATURES: 50C Over Voltage Protection 120VDC. Non-latching Hold up Time 10mSec min at max load at 120VAC, 60Hz Over Current Protection 750mA 2 Efficiency DOE Level VI Short Circuit Protection Non-Latching auto recovery. Output can be ENVIRONMENTAL shorted permanently without damage Temperature Operating -10C to +50C LED Indicators Non-operating -20C to +70C Green LED Slow Blinking No connection Relative Humidity 5 to 90% Green LED Fast Blinking No Load Green Solid Power Good EMI Green/Yellow Fast Blink Fault Detected EN55032 Class B, FCC part 15 Class B Yellow Solid with Green Blink Over/Short AS/NZS CISPR 32 Class B Current Detected AC Input Connector IEC320 C14 Output Connection 56VDC shielded RJ45 Pins 3&6 56VRTN shielded RJ45 Pins 1&2 Notes: 1. The characteristics defined are at ambient temperature of 25C unless otherwise specified Phihong is not responsible for any error and reserves the right to make changes without notice. Please visit our website at www.phihong.com for 2. Efficiency is measured after 30 minutes burn-in the most up-to-date specifications and contact information. Revision 10/25/2021