WWW.PHIHONG.COM 75 Watt Low Cost Open Frame Power Supply PSA075 Single Output Series Features 3 x 5 Low Cost Low Profile fits 1U Height Requirement Zero Minimum load Class B Conducted EMI Over Voltage and Short Circuit Protection Applications Tape/Disk Drive Systems Peripherals POS Terminals Routers Internet Servers Networking Safety Approvals CE (Low Voltage Directive) cUL/US TUV Mechanical Characteristics Length: 127mm (5in) Height: 33.1mm (1.3in) Width: 76.2mm (3in) Weight: 220g (7.76oz) Output Specifications (2) Load Ripple Regulation DC Output Max Model (3) (1) Voltage Power Min. Max. P-P (max.) Line Load PSA075-050 +5V 0A 11A 50mV 1% 3% 55W PSA075-120 +12V 0A 6.25A 120mV 1% 2% 75W PSA075-240 +24V 0A 3.125 240mV 1% 2% 75W (1) CFM forced air required with convection cooling max load is 8A for 5V model, 5A for 12V, and 2.5A for 24V models. (2) Measured by using a 12 inch twisted pair terminated with a 10uF capacitor and 0.1uF ceramic capacitor in parallel. (3) CFM forced air required with convection cooling power is 40W for 5V model and 60W for 12V and 24V models. Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for the most up-to-date specifications and contact information. Revised 11/21/2011 PSA075 Characteristics WWW.PHIHONG.COM Input: Environmental: AC Input Voltage Rating Temperature 100 to 240V AC Operation 0 to 50C Non-operation -25 to +85C AC Input Voltage Range 90V AC to 264V AC Humidity Operation 10 to 90% non-condensing AC Input Frequency 47 to 63Hz Emissions Conducted - FCC class B, EN55022 Class B Input Current Radiated FCC class B, EN55022 Class B 2.0A (RMS) at maximum load and 120V AC 1.0A (RMS) at maximum load and 240V AC Immunity ESD: EN61000-4-2 Level 3 Leakage Current RS: EN61000-4-3 Level 2 <3.5mA maximum at 264V AC, 60Hz EFT/Burst: EN61000-4-4 Level 2 Surge: EN61000-4-5 Level 3 Inrush Current CS: EN61000-4-6 Level 2 40A for 115V AC at maximum load Voltage Dips: EN61000-4-11 80A for 230V AC at maximum load Harmonic: EN61000-3-2 Class A (Cold start at ambient 25C) Flicker: EN61000-3-3 Hold-up Time General: 10mS minimum at maximum load, 115V AC Insulation Resistance Primary to Secondary: 10M ohm 500V DC Output: Efficiency at max load, 120V AC Dielectric Withstand (Hi-pot) Test 5V 65% / 12V 70% / 24V 75% Input to Ground: 1500V AC for 3 seconds, 10mA Over-Voltage Protection MTBF 125% maximum 150K hours minimum at full load, 115VAC 60Hz (measured at ambient 25C) Over-Current Protection Output equipped with Short-Circuit protection, Input Connector (Molex or Equivalent) Auto restart. Input header: Molex 09-65-2038 or equivalent (Pin 2 N.C.) Mating: Molex 09-50-1031 or equivalent Short Circuit Protection Output can be shorted permanently without Output Connector damage Output header: Molex 09-65-2068 or equivalent Mating: Molex 09-50-1061 or equivalent Dimension Diagram Unit: mm Type text