Pololu Stamped Aluminum L-Bracket Pair for Plastic Gearmotors These light-weight brackets (approximately 2 g each) are specifically designed for our larger Pololu plastic gearmotors (228:1 offset, 120:1 offset, 200:1 90-degree, and 120:1 90-degree). Each bracket features two mounting holes and one mounting slot intended for 4-size screws (not included). We also offer an extended version of this bracket that allows for even more mounting options and might work better for particular applications. A total of four 1 long 2-56 screws, for use with the 228:1 offset and 120:1 offset plastic gearmotors, and four 0.75 long 2-56 screws, for use with the 200:1 90-degree and 120:1 90- degree plastic gearmotors, are included. Two 2-56 hex nuts are also included for each bracket. Only two screws are used to mount a motor to each bracket, as shown in the pictures below: These brackets also work with the Solarbotics plastic gearmotors (GM2, GM3, GM8, and GM9), although different length mounting screws might be required. The following drawing shows the bracket dimensions in mm.Mechanical drawing for the Pololu stamped aluminum L-bracket for plastic gearmotors. Units are mm over inches . This drawing is also available as a downloadable PDF (125k pdf). Documentation on producer website.