Model 2249
Cable Assembly with BNC
Male on Each End
FEATURES:
The molded strain relief is directly bonded to the cable jacket for superior strength and durability.
Teflon insulation and nickel tarnish resistant outer shells used in the BNC connector provide long life and
reliability.
Gold plated center contacts assure the most noise free connection possible.
The connectors and cable are impedance matched.
CABLE DESIGNATION & TYPE:
RG58C/U, 50 ohm cable makes it ideal for most test and measurement applications, RF
2249-C:
transmission systems and Thinnet LAN applications.
2249-E: RG59B/U, 75 ohm cable assembly for use with broadcast, video, and other signal
applications.
2249-K: RG174/U, smaller diameter 50 ohm cable for greater flexibility in tight applications. It is
best suited for use in low power situations where small size and flexibility is important.
2249-M: RG62A/U, 93 ohm cable, use when higher impedance, > 75 ohms is required.
2249-Y: RG223/U, double shielded 50 ohm cable assembly for superior interference rejection.
RATINGS:
Capacitance Power Loss Temperature
Center
Cable Impedance Jacket Cable
Wire
Type per 1 foot / /100 Ft @ Insulation AWG Shield (w/o connectors)
Strands X
Type
Designation ohms Material OD
AWG
0,304 meters 1 MHz C
C RG58C/U 50 30.8 pf 0.44 dB PE 20 19X36 TC PVCNC .195 TCB -40 to +85
E RG59B/U 75 22.5 pf 0.60 dB PE 23 Solid BCCS PVCNC .242 BCB -40 to +60
K RG174/U 50 30.8 pf 1.90 dB PE 26 7X34 BCCS PVC .110 TCB -40 to +75
M RG62A/U 93 13.5 pf 0.25 dB SSPE 22 Solid BCCS PVCNC .242 BCB / BCB 0 to +75
Y RG223/U 50 30.8 pf 0.35 dB PE 19 Solid SPC PVCNC .212 SCB / SCB -40 to +60
AWG = American Wire Gauge SCB = Silver Coated Braid
BCB = Bare Copper Braid SPC = Silver Plated Copper
BCCS = Bare Copper Covered Steel SSPE = Semi-Solid Polyethylene
PE = Polyethylene TC = Tinned Copper
PVC = Polyvinyl Chloride TCB = Tinned Copper Braid
PVCNC = Polyvinyl Chloride Non-Contaminating
All dimensions are in inches. Tolerances (except noted): .xx = .02 (,51 mm), .xxx = .005 (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies.
Sales: 800-490-2361 Fax: 888-403-3360 Technical Support: 800-241-2060 (technicalsupport@pomonatest.com)
For Where to Buy information, visit the Pomona web site at www.pomonaelectronics.com
Rev: 100
Page 1 of 2
D1093883
Model 2249
Cable Assembly with BNC
Male on Each End
Voltage: 500 Vrms max from center conductor to shield and 33 Vac / 70 Vdc max from shield to earth in
controlled hands free testing environments. For CE compliance: not intended for hand-held use at voltage
above 33 Vrms / 70 Vdc.
MATERIALS:
BNC Male:
Body: Brass, Tarnish Resistant Nickel Plating
Dielectric: PTFE
Center Contact: Gold Plated Brass
Strain Relief:
PVC molded directly to cable and connectors
ORDERING INFORMATION: Model 2249-type-length*
Cable Type: C, E, K, M, Y. (see table for detail).
Cable Length*: 6 (15,24cm), 12 (30,5cm), 24 (61,0cm), 36 (91,4cm), 48 (121,9cm), 60 (152,4cm),
72 (182,9cm), 96 (243,84cm), 120 (304,8cm), 144 (365,76cm), 180 (457,2cm), 240 (6096cm),
300 (762cm), 360 (914,4cm), 600 (1524cm).
Ordering Example: 2249-C-72 (type C cable with a 72 (182,9cm) length)
* Custom lengths are available, contact Pomona Technical Support: 800-241-2060 (technicalsupport@pomonatest.com)
All dimensions are in inches. Tolerances (except noted): .xx = .02 (,51 mm), .xxx = .005 (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies.
Sales: 800-490-2361 Fax: 888-403-3360 Technical Support: 800-241-2060 (technicalsupport@pomonatest.com)
For Where to Buy information, visit the Pomona web site at www.pomonaelectronics.com
Rev: 100
Page 2 of 2
D1093883