Model 4488, BNC (M) Compression Style Connector & Assembly Instructions FEATURES: Do-it-yourself, field serviceable male BNC connector. Connector accepts cable types RG/U: 55, 55A, 55B, 58, 58C, 141, 141A, 142B, 223 Meets interface requirements of MIL-STD-348 MATERIALS: Body and Fittings Tarnish Resistant Nickel Plated Brass Outer Contact Tarnish Resistant Nickel Plated Brass Center Contact Gold Plated Brass Dielectric PTFE Gasket Silicone Rubber RATINGS: Voltage: Hands free usage in controlled voltage environments: 500 Vrms Max. For CE compliance: not intended for hand-held use at voltages above 33 Vrms/70Vdc. Nominal Impedance: 50 Ohms ORDERING INFORMATION: Model 4488 All dimensions are in inches. Tolerances (except noted): .xx = .02 (,51 mm), .xxx = .005 (,127 mm). All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Sales: 800-490-2361 Fax: 888-403-3360 Technical Support: 800-241-2060 (technicalsupport pomonatest.com) For Where to Buy information, visit the Pomona web site at www.pomonaelectronics.com Rev: 100 Page 1 of 3 D1094174 Model 4488, BNC (M) Compression Style Connector & Assembly Instructions 1: Style A 2: (a) (b) 3: 4: 5: (a) (b) 6: (a) (b) (c) Assembly Instructions 1. Verify all parts are present. 2. (a) Cut outer jacket and shield 5/16 (7,94mm) from cable end to the depth of the dielectric. Remove outer insulation and coax shield. (b) Cut 3/16 (4,76mm) from the cable end to the depth of the center conductor and remove dielectric exposing center conductor. 3. Slide center pin contact onto center conductor, all the way against the dielectric. Solder or crimp to center contact. 4. Slide clamp nut, washer and gasket on to coax cable. 5. (a) Slide ferrule over dielectric and under the coax braided shield. (b) Verify that ferrule is pushed up against outer jacket . 6. (a) Push assembly into body until center contact snaps into body. (b) Slide clamp nut, washer, gasket All dimensions are in inches. Tolerances (except noted): .xx = .02 (,51 mm), .xxx = .005 (,127 mm). forward. (c) Use 7/16 (11mm) wrench on the body and clamp nut, tighten to 18 22 in-lbs. All specifications are to the latest revisions. Specifications are subject to change without notice. Registered trademarks are the property of their respective companies. Sales: 800-490-2361 Fax: 888-403-3360 Technical Support: 800-241-2060 (technicalsupport pomonatest.com) For Where to Buy information, visit the Pomona web site at www.pomonaelectronics.com Rev: 100 Page 2 of 3 D1094174