Euro / Australian plug CP3 Technical Data & Fitting Instructions Description The 2 Pin European VDE to Australian Converter Plug (CP3) is an adapter that converts the European CEE VII VDE Plug to the AS NZS 3112-2000 system format. The plug is designed and manufactured to meet the requirements of AS NZS 3112-2000. It complies fully with the LVD and Plug and socket safety regulations. The design of the clamping method ensures the body of the European CEE VII plug is enclosed. It is tested for use with plug top power supplies (e.g. mobile phone chargers). Classification - Adapter, Single Portable, - Re-wireable plug, - Normal Use, - Converts CEE7 plug top power supplies and CEE7 plugs to the AS NZS 3112-2000 Format, - Suitable for class 2 devices (unearthed) only. - Not suitable for any other plug system. Certification - S marked S/415 to AS NZS 3112-2000 Relevant Standards - AS NZS 3112-2000 BS EN 61558 Transformers Rating - Voltage 230V ac (Nominal) - Current 8 amps continuous, 10 amps max. - Load 2000 Watts Max - Frequency 50 Hz - Environmental Protection IP 3X (STD AS NZS 3112-2000 Accessory Rating) - Flammability V2 (External Casing) - Mechanical Strength 100 Drops 500mm - Colour Black or White - Weight 50 Grams Typical - Finish Plain and Fine Sparkle - Retaining Screw Plain or Tamperproof Note: - Tolerance as per relevant Australian Standard. Safety Design Features - Single screw operation to secure VDE plug - No Loose parts - Non-removable cover - Plug Features designed to meet the requirements of AS NZS 3112-2000 - Meets the requirements of the Australian Plug and socket regulations. PDF created with pdfFactory trial version www.pdffactory.com Installation System The Euro / Australian plug (CP3) is designed for use within the AS NZS 3112-2000 Plug and Socket system only. Fitting The Euro / Australian plug (CP3) should be fitted as follows 1. Insert the power supply or CEE7 plug in to the Europlug 1 2. Tighten retaining screws to 6.12 Kgf.cm 3. TEST: Grip the CP3 and pull the VDE cordset/transformer to ensure fully secure, if not then increase the torque setting and further tighten. Re-test. 4. Now the CP3 is ready for use. NOTE 1: - This torque setting is for hand screwdrivers, if required, please contact us for guidance regarding power screwdriver settings NOTE: Cover in non-removable the screw does not release the cover. Service Conditions - Temperature Range O O - Storage -40 C to +70 C Ambient O O - Working -05 C to +40 C 95% RH Ambient - Altitude 2000m above sea level max - Not subject to exposure to direct radiation from the sun - Abnormal Condition Avoid pollution by smoke, chemical and flammable fumes salt laden spray, periods of high humidity > 95% relative humidity (RH) PDF created with pdfFactory trial version www.pdffactory.com