Push Mount Tie Specifications: Material : Nylon 6.6 Cable Tie Colour : Natural Cable Tie Material : PA (Polyamide) Tensile Strength N/m : 0N/mm Accessory Type : Cable Tie Press the tie into a pre-drilled hole for simple and secure one-piece harness tying and mounting Maximum Minimum Tensile L W Bundle Mounting Strength Part Number Chassis Dia. Hole mm Inches mm mm lbs kgs PWV-130 132 5 1/8 4.8 30 2.8 PWV-170 170 6 11/16 4.6 40 50 22 6 3 PWV-200 201 8 4.8 50 2.8 PWVS-100 112 4 3/8 2.5 25 18 8 2.6 PWVS-130 133 5 1/8 4.8 30 22 4.6 4.5 50 PWVS-155 157 6 1/8 3.5 36 18 3 Dimensions : Millimetres (Inches) www.element14.com www.farnell.com www.newark.com www.cpc.co.uk Page <1> 13/12/12 V1.0Push Mount Tie Part Number Table Description Part Number Cable Tie, Push MNT, NAT, 132mm, PK100 PWV-130 Cable Tie, Push MNT, NAT, 170mm, PK100 PWV-170 Cable Tie, Push MNT, NAT, 201mm, PK100 PWV-200 Cable Tie, Push MNT, BLK, 112mm, PK100 PWVS-100 Cable Tie, Push MNT, BLK, 133mm, PK100 PWVS-130 Cable Tie, Push MNT, BLK, 157mm, PK100 PWVS-155 Important Notice : This data sheet and its contents (the Information) belong to the members of the Premier Farnell group of companies (the Group) or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Groups liability for death or personal injury resulting from its negligence. pro - POWER is the registered trademark of the Group. Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com www.cpc.co.uk Page <2> 13/12/12 V1.0