This document contains data proprietary to PUI Audio Inc. Any use or reproduction, in any form, without prior written permission of PUI Audio Inc. is prohibited. 2019, PUI Audio Inc. Data Sheet AS04504PS-X-R PUI Audios eXtreme Series speakers are purpose-built for superior performance using Klippel-optimized motor designs. Forced-air vented voice coils combine with a high-grade neodymium motor for extreme power handling, extremely flat frequency response, Air is forced into the magnetic loop and a surprising amount of bass when used on both sides of the voice coil for with tuned-port or passive radiator assisted improved heat dissipation enclosures. Features: Poly-coated paper cone for warm natural sound and improved ruggedness Large voice coil diameter for high power handling Convenient mounting frame for easy integration Venting in the magnetic motor creates forced-air cooling limiting power compression Two-layer copper-clad aluminum wire for great transient response Water and dustproof to IP65 Low Qts design for use in ultra-small enclosures without inhibiting performance Specifications Parameters Values Units Rated Input Power 10 Watts Max Input Power 20 Watts Impedance 4 15% Ohms SPL 1W/0.5m (Average 0.8, 1.0, 1.2, 1.5 kHz) 86 3 dB Resonant Frequency 170 20% Hz Frequency Range (-10 dB) 90 ~ 20,000+ Hz Frame Material Stamped Steel - Magnet Material NdFeB - Weight 63 Grams Ingress Protection Rating IP65 - Recommended Sealed Enclosure Volume Range (Qtc 0.707)* 0.05 ~ 0.40 Liters Recommended Vented Enclosure Volume* 0.40 Liters Vent Size and Tuning Frequency 20mm dia. x 244mm L, 100 Hz - *Recommended enclosure volumes do not include volume displaced by speaker or vent PUI Audio, Inc., 3541 Stop Eight Road, Dayton, OH 45414 Tel: (937) 415-5901 Fax: (937) 415-5925 This document contains data proprietary to PUI Audio Inc. Any use or reproduction, in any form, without prior written permission of PUI Audio Inc. is prohibited. 2019, PUI Audio Inc. Speaker Specifications (continued) - Acceptable Soldering Methods Hand Solder Should not be audible with 6.32V sine wave from 90 Hz to - Buzz, Rattle, etc. 20 kHz RoHS 2015/863/EU, - Environmental Compliances REACH 197 Cone shall move forward when a positive voltage is applied to - the positive terminal Polarity Operating Temperature -25 ~ +60 C Measurement Method (1W input power with microphone spaced at 50cm) PUI Audio, Inc., 3541 Stop Eight Road, Dayton, OH 45414 Tel: (937) 415-5901 Fax: (937) 415-5925