Pulse Jack SMT Power Inductors Power Beads - PA4025.XXXHL Series E l e c t r o n i c s Current Rating: Over 86Apk Inductance Range: 150nH to 360nH Height: 12.3mm Max Footprint: 10.0mm x 6.8mm Max Halogen Free 7 Electrical Specifications 25C Operating Temperature - 40C to +130C 5 1 2 Saturation Current Inductance Inductance 3 4 6 Part Irated DCR Heating Current (A TYP) 0ADC Irated Number (ADC) (mW nominal) (A TYP) (nH +/- 10%) (nH TYP) 25C 100C PA4025.151HL 150 150 58 75+ 75+ PA4025.181HL 180 180 58 75+ 75+ 0.29 +/- 10% 58 PA4025.231HL 230 185 62 75 62 PA4025.361HL 360 350 36 46 36 PA4025.471HL 470 460 25 35 25 NOTES: 1. Inductance measured at 100kHz, 100mVrms. 7. In high volt*time applications, additional heating in the component can occur due to core losses in the inductor which may neccessitate derating the current in order to limit the temperature rise of the component. To deter- 2. Inductance at Irated is the value of the inductance at 25C at the listed rated current. mine the approximate total losses (or temperature rise) for a given application, the coreloss and temperature 3. The rated current as listed is either the saturation current (25C or 100C) or the heating current depending on rise curves can be used. which value is lower. 8. Optional Tape & Reel packaging can be ordered by adding a T suffix to the part number (i.e. PA4025.361HL 4. The nominal DCR is measured from point a to point b , as shown below on the mechanical drawing. becomes PA4025.361HLT). 5. The saturation current is the typical current which causes the inductance to drop by 20% at the stated ambient Pulse complies to industry standard tape and reel specification EIA481. The tape and reel for this product has a temperatures (25C, 100C ). This current is determined by placing the component in the specified ambient envi- width (W=32mm), pitch (Po=16mm) and depth (Ko=13mm). ronment and applying a short duration pulse current 9. The temperature of the component (ambient plus temperature rise) must be within the stated operating tem- (to eliminate self-heating effects) to the component. perature range. 6. The heating current is the DC current which causes the part temperature to increase by approximately 40C when used in a typical application. Schematics Mechanical PA4025.XXXHL M1 CN Weight ........... xx grams Tape & Reel ......... xx/reel Inches Dimensions: mm Unless otherwise specified, .010 all tolerances are 0,25 pulseelectronics.com P733.B (02/15) 1Pulse Jack SMT Power Inductors Power Beads - PA4025.XXXHL Series E l e c t r o n i c s PA4025.XXXHL, LvsI, 25C 500 450 400 350 300 250 200 150 100 50 0 01020304050607080 Current (A) .151HL .181HL .231HL .361HL .471HL PA4025.XXXHL, Lvsl, 100C 500 450 400 350 300 250 200 150 100 50 0 0 10 20 30 40 50 60 70 80 Current (A) L .151HL .181HL .231HL .361HL .471HL pulseelectronics.com P733.B (02/15) 2 Inductance (nH) Inductance (nH)