SMT Power Inductors Power Beads - PA5189.XXXHLT Series Current Rating: Over 20.5Apk Inductance Range: 100nH Height: 4.1mm Max Footprint: 4.1mm x 4.1mm Max 7 Electrical Specifications 25C Operating Temperature - 40C to +130C 5 1 2 Saturation Current Inductance 3 4 Inductance 6 Part Irated DCR Heating Current (A TYP) 0ADC Irated Number (ADC) (m nominal) (A TYP) (nH +/- 15%) (nH TYP) 25C 100C PA5189.101HLT 100 70 20.5 0.39+/- 10% 20.5 17 39 NOTES: 1. Inductance measured at 100kHz, 100mVrms. 7. In high volt*time applications, additional heating in the component can occur due 2. Inductance at Irated is the value of the inductance at 25C at the listed rated current. to core losses in the inductor which may neccessitate derating the current in order 3. The rated current as listed is either the saturation current (25C or 100C) or the heat- to limit the temperature rise of the component. To determine the approximate total ing current depending on which value is lower. losses (or temperature rise) for a given application, the coreloss and temperature rise curves can be used. 4. The nominal DCR is measured at point 2. , as shown below on the mechanical 8. Parts with the HLT suffix are sold in tape and reel packaging. Pulse complies to drawing. industry standard tape and reel specification EIA-481. 5. The saturation current is the typical current which causes the inductance to drop by The tape and reel for this product has a width (W=16mm), pitch (Po=8mm) and depth 20% at the stated ambient temperatures (25C, 100C ). This current is determined by (Ko=4.65mm). Samples of these parts can be ordered by removing the HLT suffix and placing the component in the specified ambient environment and applying a short replacing with HL. duration pulse current (to eliminate self-heating effects) to the component. 9. The temperature of the component (ambient plus temperature rise) must be within 6. The heating current is the DC current which causes the part temperature to increase by the stated operating temperature range. approximately 40C when used in a typical application. Schematic Mechanical PA5189.XXXHLT 4.1 MAX PA5189.XXXHL 4.1 MAX 12 Weight: ....... 2.74grms 4.1 MAX Tape &Reel: ....... 1500/ Reel Dimensions: mm 1 2 2. 2. Unless otherwise specified , all tolerances are 0.25 0.90 1.7 2.0 4.7 1.3 3.9 P905.A (04/21) PulseElectronics.com 1XXX SMT Power Inductors Power Beads - PA5189.XXXHLT Series TAPE & REEL INFO F 1 W P1 K0 SURFACE MOUNTING TYPE, REEL/TAPE LIST TAPE SIZE REEL SIZE (mm) QTY (mm) TYPE W 0.30 K0 0.1 P1 0.1 F 0.1 PCS/REEL PA5189.XXXHLT 16.0 4.65 8.0 7.5 1500 PA5189.101HLT, L vs I, Curve PA5189.101HL L vs I curve 110 100 90 80 70 60 50 40 0 5 10 15 20 25 30 Current I (A) 25 100 P905.A (04/21) PulseElectronics.com 2 Inductance (nH)