SMT Power Inductors Power Beads - PA5300.XXXHLT Series Current Rating: Over 66Apk Inductance Range: 120nH to 220nH Height: 15.5mm Max Footprint: 11mm x 10mm Max 7 Electrical Specifications 25C Operating Temperature - 40C to +130C 5 1 2 Saturation Current Inductance Inductance 3 4 6 Part Irated DCR Heating Current (A TYP) 0ADC Irated Number (ADC) (MAX) (A TYP) (nH +/- 15%) (nH TYP) 25C 100C PA5300.121HLT 120 114 115 144 120 0.10 115 PA5300.221HLT 220 159 80 80 66 NOTES: 1. Inductance measured at 100kHz, 100mVrms. 7. In high volt*time applications, additional heating in the component can occur due 2. Inductance at Irated is the value of the inductance at 25C at the listed rated current. to core losses in the inductor which may neccessitate derating the current in order 3. The rated current as listed is either the saturation current (25C or 100C) or the heat- to limit the temperature rise of the component. To determine the approximate total ing current depending on which value is lower. losses (or temperature rise) for a given application, the coreloss and temperature rise curves can be used. 4. The nominal DCR is measured at point 2. , as shown below on the mechanical 8. Parts with the HLT suffix are sold in tape and reel packaging. Pulse complies to drawing. industry standard tape and reel specification EIA-481. 5. The saturation current is the typical current which causes the inductance to drop by The tape and reel for this product has a width (W=24mm), pitch (Po=16mm) and depth 20% at the stated ambient temperatures (25C, 100C ). This current is determined by (Ko=10.5mm). Samples of these parts can be ordered by removing the HLT suffix and placing the component in the specified ambient environment and applying a short replacing with HL. duration pulse current (to eliminate self-heating effects) to the component. 9. The temperature of the component (ambient plus temperature rise) must be within 6. The heating current is the DC current which causes the part temperature to increase by the stated operating temperature range. approximately 40C when used in a typical application. Schematic Mechanical PA5300.XXXHLT PA5300.XXXHL 11 MAX D/C CTRY 10 MAX 12 15.5 MAX Weight: 2.2.74grms Tape & Reel: 150/Reel Dimensions: mm d 0.10 2 SURFACES Unless otherwise specified, 2. all tolerances are 0.25 (4.3) 10.70 (6.5) 7.00 3.45 (2.6) PulseElectronics.com P907.A (04/21) 1SMT Power Inductors Power Beads - PA5300.XXXHLT Series TAPE & REEL INFO CIRCULAR HOLES A F PA5300.XXXHL W D/C CTRY 1 K0 P1 A SURFACE MOUNTING TYPE, REEL/TAPE LIST TAPE SIZE REEL SIZE (mm) QTY (mm) TYPE W 0.30 K0 0.1 P1 0.1 0.1 PCS/REEL PA5300.XXXHLT 32.0 15.4 20.0 14.2 150 PulseElectronics.com P907.A (04/21) 2