SMT Power Inductors Power Beads - PG1712.XXXHLT Series POWER PRODUCTS Current Rating: Over 100Apk Inductance Range: 100nH to 220nH Height: 9.3mm Max Footprint: 9.6mm x 6.4mm Max 7 Electrical Specifications 25C Operating Temperature - 40C to +130C 5 1 2 Saturation Current Inductance Inductance 3 4 6 Part Irated DCR Heating Current (A TYP) 0ADC Irated Width (W) Number (ADC) (m nominal) (A TYP) (nH +/- 10%) (nH TYP) 25C 100C + PG1712.101HLT 100 100 65 112 98 6.5 PG1712.121HLT 115 115 65 97 80 0.17+/-5% 65 PG1712.151HLT 150 150 65 75 63 6.4 PG1712.331HLT 220 175 50 44 39 NOTES: 1. Inductance measured at 100kHz, 100mVrms. 7. In high volt*time applications, additional heating in the component can occur due to core losses in the inductor which may neccessitate derating the current in order to limit the temperature rise of the component. To deter- 2. Inductance at Irated is the value of the inductance at 25C at the listed rated current. mine the approximate total losses (or temperature rise) for a given application, the coreloss and temperature 3. The rated current as listed is either the saturation current (25C or 100C) or the heating current depending on rise curves can be used. which value is lower. 8. Parts with the HLT suffix are sold in tape and reel packaging. Pulse complies to industry standard tape and reel 4. The nominal DCR is measured from point a to point b , as shown below on the mechanical drawing. specification EIA-481. 5. The saturation current is the typical current which causes the inductance to drop by 20% at the stated ambient The tape and reel for this product has a width (W=24mm), pitch (Po=16mm) and depth (Ko=10.3mm). Samples of temperatures (25C, 100C ). This current is determined by placing the component in the specified ambient envi- these parts can be ordered by removing the HLT suffix and replacing with HL. ronment and applying a short duration pulse current 9. The temperature of the component (ambient plus temperature rise) must be within the stated operating tem- (to eliminate self-heating effects) to the component. perature range. 6. The heating current is the DC current which causes the part temperature to increase by approximately 40C when used in a typical application. Schematic Mechanical PG1712.XXXHLT Weight 2.60/ grams ...... Tape & Reel 300/ reel ...... Dimensions: mm Unless otherwise specified, all toler - ance are 0.25. Power.PulseElectronics.com P845.B (07/20) 1SMT Power Inductors Power Beads - PG1712.XXXHLT Series POWER PRODUCTS PG1712.XXXHL, LvsI, 25C 250 200 150 100 50 0 0 20 40 60 80 100 120 Current (A) .101HL 25C .121HL 25C .151HL 25C .221HL 25C PG1712.XXXHL, LvsI, 100C 250.0 200.0 150.0 100.0 50.0 0.0 0 20 40 60 80 100 120 Current (A) .101HL 100C .121HL 100C .151HL 100C .221HL 100C Power.PulseElectronics.com P845.B (07/20) 2 Inductance (nH) Inductance (nH)