3 SIGNAL LAMPS Signal lamps with integrated LED 3 - 3 Signal lamp with integrated LED - 5 mm, solder terminals 3 - 5 Signal lamp with integrated LED - 7 mm, solder terminals 3 - 9 Signal lamp with integrated LED - 9.1 mm, solder terminals 3 - 11 Signal lamp with integrated LED - 10 mm, quick-connect terminal 3 - 13 Signal lamp with integrated LED - 11.1 mm, solder terminals 3 - 16 Signal lamp with integrated LED - 16.2 mm, quick-connect terminal 3 - 18 Signal lamp with integrated LED - 16.2 mm, screw terminals 3 - 20 Signal lamp with integrated LED - 18,2 mm, quick-connect terminal 3 - 23 Signal lamp with integrated LED - 22.3 mm, screw terminals 3 - 25 Signal lamp with integrated LED - 30.5 mm, quick connector 3 - 27 3 - 31 Signal lamps with integrated lamp Signal lamp with integrated neon lamp - 7 mm, solder terminals 3 - 33 Signal lamp with integrated neon lamp - 10 mm, quick-connect terminal 3 - 35 Signal lamp with integrated neon lamp - 10 mm, quick-connect terminal 3 - 37 Signal lamp with integrated neon lamp - 14 mm, quick-connect terminal 3 - 40 SIGNAL LAMPS GENERAL INFORMATION Signal Lamps with integral lamps/LED Standard mounting dimensions The soldered lamps/LED without base cannot be We recommend use of mounting hole diameters 16, 22 replaced. and 30 mm, as these comply with international standard recommendations and DIN standards. Signal Lamps with lamp socket An integral lamp socket allows replacement of lamps/LED Limit values of the appropriate type. The voltage specified as the limit value is the standard insulating voltage for the signal lamps. The permitted Filament operating life ambient temperatures are always specified in conjunction Operating life specifications refer to AC voltage operation. with the maximum power of the lamps used, and the If operated with DC voltage, these values are reduced by signal lamp should be located outside of the space sub- 40%. ject to increased temperature. Color and lenses transparent = clear, grooved on inner surface for better light diffusion opaque = translucent but not clear Neon lamps Neon lamps may glow on a short time after having been To avoid this, a parallel resistor with 1,2 M 1/4 W, can be switched off, for example in combination with long wires. used. 3 3-2