Constant Current Operation Features Suitable for High Brightness LED Products LIGHTLINE Built-In Active PFC Function LED DRIVER Overvoltage-, Short Circuit- and Over- AC/DC-Converter temperature Protection with 5 year Warranty Built-In 3 in 1 Dimming IP67 Rated Class 2 Power Unit UL1310 Selection Guide Part Output Rated Rated Output Efficiency Number Voltage Power Current Voltage Range 45 Watt PFC (VDC) (W) (mA) (V) (typ.) RACD45-700A 57 40 70 - 700 40 - 57 87% Single 230 500 21-39 Triac 82 RACD45-1050A 48 48 105 - 1050 33 - 48 87% 12-18 RACD45-1250A 36 45 125 - 1250 24 - 36 86% Output RACD45-1850A 24 45 185 - 1850 15 - 24 85% Specifications (measured at 230VAC and 25C ambient temperature) Input Voltage Range 90-305 VAC Input Frequency Range 47-63Hz Power Factor (Full Load) 120VAC >0.98 240VAC >0.93 277VAC >0.90 RoHS 2011/65/EU THD Full Load, 115VAC 13% max. 6/6 E340696 Full Load, 230VAC 19% max. DC Dimming Open = 100% DC 1-10V EN 61347-1 Certified PWM Dimming Open = 100% Duty 10% - 100% EN 61347-2-13 Certified Freq. 500Hz - 3000Hz UL8750 Certified Voltage Hi=10V, Low=0V Resistance Dimming 10K - 100K Current Accuracy 5% RACD45-A AC Input Current 100-240VAC 0.6A 277VAC 0.25A Inrush Current (Cold Start) 240VAC 70A Derating-Graph Leakage Current <0.5mA / 240VAC Start-up Time (at Full Load) <2sec (Ambient Temperature) Isolation Voltage 3.75kVAC / 1 minute Short Circuit Protection Hiccup Over Voltage Protection 24V 26.4 - 31.2V A 3 A 36V 39.6 - 46.8V 48V 52.8 - 62.4 V /+A - A 57V 62.7 - 70V Over Temperature Protection Latch Mode 105 10C , A Vibration 10-500Hz, 2G, 60Min. along X, Y and Z A Storage Humidity 10% - 90% RH Operating Humidity 20% - 90% RH Non-Condensing 0* + -+ Weight 420g ) Operating Temperature -30C to +50C Storage Temperature -40C to +60C Note: Ripple & Noise 24V 200mV All LED Drivers may not be used without a load. (at 20MHz bandwith using 0.1uF & 47uF capacitor) all others 250mV They must be switched on the primary side only. IP Rating IP67 Noncompliance may damage the LED or reduce Isolation Resistance 100M / 500VDC at 25C its lifetime. Dimension (L*W*H) 179*45.1*32.5mm Refer to Application Notes continued on next page L-48 REV: 0/2015 www.recom-power.com NOT RECOMMENDED FOR NEW DESIGNS * 2) RACD45-A ) 89 RACD45-A LIGHTLINE AC/DC-Converter Series Specifications (measured at 230VAC and 25C ambient temperature) Safety Standards LED Lighting Safety Report: E340696 UL8750 LED Lighting Safety (Canada) Report: E340696 cUL8750 Class 2 Power Supply Safety Report: E340696 UL1310 Extra Low-Voltage Class 2 Output Report: E340696 CSA C22.2 No. 223-M91 LED equipment for lighting application Report: E340696 CSA C22.2 No. 250.13-12 EN61347-1 EN61347-2-13 EN61000-3-2 Class C EN61000-3-3 EN61000-4-2,3,4,5,6,8,11 EN61547 EN55015 FCC15 Design Lifetime 70 x 10 hours max. MTBF (+25C) using MIL-HDBK 217F 200 x 10 hours min. 3 in 1 Dimming Control (DC / PWM / Resistance) 10K-100K Resistor Dimmable (Typical): Resistor Single-Driver 10K 20K 30K 40K 50K 60K 70K 80K 90K 100K Multi-Driver 10K/N 20K/N 30K/N 40K/N 50K/N 60K/N 70K/N 80K/N 90K/N 100K/N 80% Iout (%) 10% 20% 30% 40% 50% 60% 70% 90% 100% The length of extended wire for DIM+/- shall not exceed 20 meters. (wire 20m) N = The number of dimmer drivers should not exceed 15. (N 15mS) DC: 1-10V Dimmable (Typical) Maximum Number of LED drivers per circuit breakers Condition Circuit Breaker Circuit Breaker Current Typ 10A 16A 20A 25A 115VAC, 1Ohm C 16 28 31 43 % % 90 phase angle DC: 10V / PWM Dimmable (Typical) B 17 28 33 41 230VAC, 1Ohm 90 phase angle C 24 39 47 57 B 20 32 38 47 277VAC, 1Ohm 90 phase angle C 28 44 54 66 ) * * ( Package Style & Pinning -, : & ( . ) ) 9 4 - ) 4 5 21 7 20 4 (> *. * : & ,+% 1 4 ( * %+ / C + 0 *+%/ ( . - C + %. - *%+ 9 G 0 20 ( ( , . - * . %. 4 %. / C + - C + * The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOMs explicit written consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications. www.recom-power.com REV: 0/2015 L-49 ( ( 1 8