RPMB5.0-2.0-EVM-1 Recom Power

Evaluation platform for RPMB-2.0 Power Modules Features Thermal design considerations included Evaluation Module EMI Class B filter Evaluation Easy evaluation of control, power good and Module sensing functions RPMB-2.0-EVM-1 Description The RPMB-2.0-EVM-1 generates a constant output voltage with an output current up to 2.0A from an external DC source. Functions of the RPMB-2.0 such as trimming, control, and sensing can be evalu- ated. Also the behavior in overload or over temperature can be evaluated easily before design-in. Selection Guide Part Input Voltage nom. Output Vout Output Number Range Voltage Adjust Range Current max. VDC VDC VDC A RPMB3.3-2.0-EVM-1 4-36 3.3 1-9 2.0 RPMB5.0-2.0-EVM-1 5.5-36 5 1-9 2.0 RPMB12-2.0-EVM-1 12.8-36 12 9-24 2.0 RPMB15-2.0-EVM-1 16-36 15 9-24 2.0 Quick Start Guide 1) Connect P1 to power supply (observe correct polarity ) 2) Connect P2 to a Load 3) Connect sense to the required potential The sense preset is via R1 directly at the power module, so the preset voltage is very accurate at the output of the RPMB-2.0. To equalize ohmic losses of the output filter, remove the resistor at R1, and solder a 0 resistor at R2. 4) Disable the device via R5 The device is preset as normally on. It can be disabled by pulling the CTRL pad to GND. Short R5 to disable the device. www.recom-power.com REV.: 0/2020 P-1RPMB-2.0-EVM-1 Evaluation Module Specifications (measured Ta= 25C, full load after warm up unless otherwise stated) Component Placement RPM-BC-EVM-2 L4 L9 R2 L1 L5 L8 C7 9 SENSE L3 L7 L2 C6 1 U1 8 L6 VIN VOUT P1 P2 1 1 2 2 GND 2 GND 7 R10 R5 C10 R9 3 4 5 6 CTRL GND PGOOD SEQ Connector Description P1 P2 Pin Name Description Pin Name Description 1 V Positive Input Voltage (observe correct polarity ) 1 V Positive Output Voltage in out 2 GND Common GND 2 GND Common GND PADS direct connection Pin Name Description 1 V Positive Input Voltage in 2 GND Common GND 3 CTRL CTRL Pin (leave open if not used) 4 GND Common GND 5 PGOOD Power good signal 6 SEQ Sequencing and soft start (not applicable for RPMB-2.0-EVM-1) 7 GND Common GND, can connect oscilloscope GND for measurement 8 V Positive Output Voltage out 9 SENSE Output Voltage Sense Pin (leave open if not used) www.recom-power.com REV.: 0/2020 P-2 C1 C2 C11 C3 C4 C12 C5 R1 R6 R4 C8 C9