IDT74CBTLV3862 LOW-VOLTAGE 10-BIT BUS SWITCH WITH ACTIVE HIGH AND LOW ENABLES INDUSTRIAL TEMPERATURE RANGE LOW-VOLTAGE 10-BIT IDT74CBTLV3862 BUS SWITCH WITH ACTIVE HIGH AND LOW ENABLES FEATURES: DESCRIPTION: 5 A/B bi-directional switch The CBTLV3862 provides ten bits of high-speed bus switching with low Isolation Under Power-Off Conditions on-state resistance of the switch allowing connections to be made with Over-voltage tolerant minimal propagation delay. Latch-up performance exceeds 100mA The device is organized as one 10-bit bus switch. The switches are VCC = 2.3V - 3.6V, normal range controlled by independent active-low enable (OE) and active-high enable ESD >2000V per MIL-STD-883, Method 3015 >200V using (OE) controls. machine model (C = 200pF, R = 0) To ensure the high-impedance state during power up or power down, Available in SSOP, QSOP, and TSSOP packages OE should be tied to VCC through a pullup resistor the minimum value of the resistor is determined by the current-sinking capability of the driver, and OE should be tied to GND. APPLICATIONS: 3.3V High Speed Bus Switching and Bus Isolation FUNCTIONAL BLOCK DIAGRAM SIMPLIFIED SCHEMATIC, EACH SWITCH 2 22 A1 B1 SW A B 11 13 A10 SW B10 1 OE 23 OE OE OE The IDT logo is a registered trademark of Integrated Device Technology, Inc. INDUSTRIAL TEMPERATURE RANGE DECEMBER 2014 1 c 2014 Integrated Device Technology, Inc. DSC-5264/3IDT74CBTLV3862 LOW-VOLTAGE 10-BIT BUS SWITCH WITH ACTIVE HIGH AND LOW ENABLES INDUSTRIAL TEMPERATURE RANGE (1) PIN CONFIGURATION ABSOLUTE MAXIMUM RATINGS Symbol Description Max. Unit VCC Supply Voltage Range 0.5 to 4.6 V VI Input Voltage Range 0.5 to 4.6 V OE 1 24 VCC Continuous Channel Current 128 mA A1223 OE IIK Input Clamp Current, VI/O < 0 50 mA A2322 B1 TSTG Storage Temperature Range 65 to +150 C NOTE: A3421 B2 1. Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS may cause A4520 B3 permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational A5619 B4 sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. A6 B5 718 B6 A7817 A8 9 16 B7 A9 10 15 B8 A10 11 14 B9 (1) FUNCTION TABLE GND 12 13 B10 Inputs OE OE Function SSOP/ QSOP/ TSSOP L L Disconnect TOP VIEW L H Disconnect H L A Port = B Port H H Disconnect NOTE: 1. H = HIGH Voltage Level L = LOW Voltage Level (1) OPERATING CHARACTERISTICS Symbol Parameter Test Conditions Min. Max. Unit VCC Supply Voltage 2.3 3.6 V VIH High-Level Control Input Voltage VCC = 2.3V to 2.7V 1.7 V VCC = 2.7V to 3.6V 2 VIL Low-Level Control Input Voltage VCC = 2.3V to 2.7V 0.7 V VCC = 2.7V to 3.6V 0.8 TA Operating Free-Air Temperature 40 +85 C NOTE: 1. All unused control inputs of the device must be held at VCC or GND to ensure proper device operation. 2