ISL54233IRUZ-T7A Renesas

DATASHEET ISL54233 FN7918 Rev.1.00 Wideband Differential 3:1 Multiplexer Dec 12, 2018 The ISL54233 is a single supply differential 3 to 1 multiplexer Features that operates from a single supply in the range of 2.7V to 4.6V. It High Speed (480Mbps) and Full Speed (12Mbps) Signaling was designed to multiplex between three different differential Capability per USB 2.0 on All Ports data sources, allowing the multiplexing of USB 2.0 high speed data signals, UART data signals and digital video through a Digital Video Transmission common headphone connector in Personal Media Players and COM Pins Allow Negative Swings to -2V other portable battery powered devices. All Switches OFF Mode The switch channels have low ON capacitance and high Power OFF Protection bandwidth (1.6GHz) to pass USB high speed signals (480Mbps) and digital video signals with minimal edge and phase distortion COM Pins Overvoltage Tolerant to 5.5V and can swing rail-to-rail to pass UART and full-speed USB Low ON Capacitance 240MHz 2.8pF signals. -3dB Frequency 1.6GHz All channels of the multiplexer can be turned OFF (disabled) by Single Supply Operation (V ) 2.7V to 4.6V DD driving the C0 and C1 logic pins to the low state. Available 12 Ld UTQFN and 12 Ld TQFN Packages The ISL54233 is available in a tiny 12 Ld 2.2mmx1.4mm Compliant with USB 2.0 Short Circuit Requirements Without ultra-thin QFN and 12 Ld 3mmx3mm TQFN package. It operates Additional External Components over a temperature range of -40C to +85C. Pb-Free (RoHS Compliant) Related Literature Applications Technical Brief TB363 Guidelines for Handling and MP4 and Other Personal Media Players Processing Moisture Sensitive Surface Mount Devices (SMDs) Mobile Phone/Smart Phone Tablets, Readers, GPS and MHL 1 3.3V V BUS CONTROLLER 0 VDD C0 C1 -1 3D- USB LOGIC TRANSCEIVER 3D+ 4M -2 2D- DIGITAL COM - -3 VIDEO 2D+ COM + -4 1D- R = 50 L UART 1D+ V = 0dBm, 0.86VDC BIAS IN ISL54233 GND 1M 10M 100M 1G 2G FREQUENCY (Hz) FIGURE 1. TYPICAL APPLICATION FIGURE 2. BANDWIDTH CHARACTERISTICS CURVE FN7918 Rev.1.00 Page 1 of 19 Dec 12, 2018 USB/DATA JACK NORMALIZED GAIN (dB)ISL54233 Pin Configuration 12 LD 2.2X1.4 UTQFN 12 LD 3x3 TQFN TOP VIEW TOP VIEW 3D- V C0 3D- V C0 DD DD 12 11 10 12 11 10 PD 4M LOGIC LOGIC 1 9 3D+ C1 3D+ 1 9 C1 CONTROL CONTROL 4M 2D- 2 8 COM - 2D- COM - 2 8 7 COM + 2D+ 3 3 7 2D+ COM + 4M 4M 465 4 5 6 1D- 1D+ GND 1D- 1D+ GND NOTE: 1. ISL54233 switches shown for C1 = Logic 1 and C0 = Logic 0. Pin Descriptions Truth Table UTQFN TQFN NAME FUNCTION C1 C0 MODE COMMENTS 1 1 3D+ USB3/DV Differential Input 0 0 Wired-OR Audio All switches open 2 2 2D- USB2/DV Differential Input 0 1 USB/DV 1 1D- and 1D+ ON 3 3 2D+ USB2/DV Differential Input 1 0 USB/DV 2 2D- and 2D+ ON 4 4 1D- USB1/DV Differential Input 1 1 USB/DV 3 3D- and 3D+ ON 5 5 1D+ USB1/DV Differential Input C0, C1: Logic 0 when 0.5V or float, Logic 1 when 1.4V with V in DD range of 2.7V to 3.6V. 6 6 GND Ground Connection 7 7 COM+ Data Common Pin 8 8 COM- Data Common Pin 9 9 C1 Digital Control Input 10 10 C0 Digital Control Input 11 11 V Power Supply DD 12 12 3D- USB3/DV Differential Input - PAD PAD Thermal Pad. Tie to Ground or Float FN7918 Rev.1.00 Page 2 of 19 Dec 12, 2018 NOLONGERAVAILABLEORSUPPORTED