R0E000010ACB20 Renesas

User s Manual R20UT2740EJ0100 R0E000010ACB20 Rev.1.00 Dec 01, 2013 Isolator for the E1 Emulator of RH850 and RL78 1. Preface 13 1 CN1 14 2 The R0E000010ACB20 is an isolator for the E1 emulator of RH850 and RL78. This product is used for a debugging environment where there is a GND gap between the user system and emulator system. Package Components 14 2 CN2 13 1 Before using this product, check if your R0E000010ACB20 contains all of these items. Table 1.1 Package Components Item Qty. R0E000010ACB20 (Isolator for the E1 emulator) 1 R0E000010ACB20 User s Manual (English) (This manual) 1 R0E000010ACB20 User s Manual (Japanese) 1 Note: Please handle this product as precision equipment for transportation. Important CAUTION Caution on Isolation Voltage: This product is intended to isolate a small and electrically safe GND gap between the user system and emulator system. In any case isolation voltage must be maintained within SELV limits i.e. less than 42.4VAC, or 60VDC. The isolator must never be used as an element of a safety isolation system. The part could be expected to function correctly at higher voltage across the isolation barrier but then the circuitry on both sides of the barrier must be regarded as operating at an unsafe voltage and further isolation/insulation systems must form a barrier between these circuits and any user-accessible circuitry according to safety standard requirements. Caution to Be Taken for Disposal: Penalties may be applicable for incorrect disposal of this waste, in accordance with your national legislation. European Union regulatory notices: The WEEE (Waste Electrical and Electronic Equipment) regulations put responsibilities on producers for the collection and recycling or disposal of electrical and electronic waste. Return of WEEE under these regulations is applicable in the European Union only. This equipment (including all accessories) is not intended for household use. After use the equipment cannot be disposed of as household waste, and the WEEE must be treated, recycled and disposed of in an environmentally sound manner. Renesas Electronics Europe GmbH can take back end of life equipment, register for this service at R0E000010ACB20 User s Manual CAUTION Cautions to Be Taken for Connecting the Isolator: Always switch OFF the power before connecting or disconnecting this product. This product has some switches. Make settings depending on debugging interface you use. Before changing settings power off this product and other connected devices. To connect this product to the user system align the 1 pin of the connector to the right position. To connect this product to the emulator align the 1 pin of the connector to the right position. Cautions to Be Taken for Power Supply When Connecting: This product needs the power supply from both user system and E1 emulator. Do not change the voltage of the user system after turning on the power. When an attempt to connect the emulator debugger to the user system has failed, turn off the user system and then unplug and plug the USB cable of the emulator before trying again. Cautions to Be Taken for Power Supply When Disconnecting: Turn off the power supply of the user system promptly when you disconnect the user system from the emulator debugger. If the power supply of a user system continues being ON, a user program will carry out a reset start. Moreover, you may fail to reconnect the emulator debugger to the user system. When an attempt to reconnect to the user system has failed, turn off the user system and then unplug and plug the USB cable of the emulator before trying again. European Union regulatory notices This product complies with the following EU Directive. Environmental Compliance and Certification: Waste Electrical and Electronic Equipment (WEEE) Directive 2012/19/EC R20UT2740EJ0100 Rev.1.00 Page 2 of 8 Dec 01, 2013