XUM725050.000JU6I Renesas

XU Family of Low Phase Noise XU Quartz-based PLL Oscillators Datasheet Description Features 1 Frequency range: 0.016MHz to 1500MHz The XU devices are low phase noise quartz-based PLL oscillators supporting a large range of frequencies and output interface Output types: LVDS, LVPECL, HCSL, LVCMOS types. These devices are designed to operate at three different Supply voltage options: 1.8V, 2.5V, or 3.3V power supplies and are available in multiple package sizes as well Phase jitter (1.875MHz to 20MHz): 100fs typical as temperature grades. Phase jitter (12kHz to 20MHz): 300fs typical With a patented one-time program (OTP) allowing for infinite Package options: memory shelf life, the XU devices can be programmed to generate 5.0 3.2 1.2 mm an output frequency from 16kHz to 1500MHz with a resolution as low as 1Hz accuracy. The configuration capability of this family of 7.0 5.0 1.3 mm devices allows for fast delivery times for both sample and large Operating temperature: -20C to +70C production orders. Frequency stability options: 20, 25, 50, or 100 ppm Operating temperature: -40C to +85C Pin Assignments Frequency stability options: 25, 50, or 100 ppm Operating temperature: -40C to +105C NOTE: To minimize power supply line noise, a 0.01F bypass capacitor should be placed between V (Pin 6) and GND (Pin 3). Frequency stability options: 50 or 100 ppm DD E/D / NC 1 VDD 6 NC / E/D 2 OUT2 5 GND 3 4 OUT Table 1. Pin Description Pin Name Description a b Enable/Disable E/D 1 NC No connect No connect NC 2 a b E/D Enable/Disable 3 GND Connect to ground 4 OUT Output c 5 OUT2 Complementary output 6 V Supply voltage DD a Pulled high internally = output enabled. b Low = output disabled. c Do not connect for LVCMOS. For XLVCMOS both OUT and OUT2 are ON and in opposite phase. See Ordering Information for more details. 1 There is a dead zone between 1037.5MHz to 1300MHz. Contact support for frequencies above 1300MHz. 2021 Renesas Electronics Corporation 1 January 19, 2021XU Datasheet Absolute Maximum Ratings Stresses above the ratings listed below can cause permanent damage to the device. The ratings, which are standard values for Renesas commercially rated parts, are stress ratings only. Functional operation of the device at these or any other conditions above those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical parameters are guaranteed only over the recommended operating temperature range. Table 2. Absolute Maximum Ratings Item Rating V -0.5 to +5.0V DD E/D -0.5V to V + 0.5V DD OUT -0.5V to V + 0.5V DD Storage Temperature -55C to 125C Maximum Junction Temperature 125C Core Current 65mA maximum Theta J 75.9 C/W 89.6 C/W A JU6 JS6 Theta J 48.6C/W 54.3 C/W B ESD Compliance Table 3. ESD Compliance Human Body Model (HBM) 1000V Mechanical Testing Table 4. Mechanical Testing * Parameter Test Method Mechanical Shock Half-sine wave with 0.3ms 3000G. X, Y, Z each direction 1 time. Frequency: 10 55MHz amplitude: 1.5mm. Mechanical Vibration Frequency: 55 2000Hz peak value: 20G. Duration time: 4H for each X,Y,Z axis total 12hours. High Temp Operating Life (HTOL) 2000 hours at 125C (under power). Hermetic Seal Gross leak (air leak test). Fine leak (Helium leak test) He-pressure: 6kgf/cm 2 hours. * MSL level does not apply. Solder Reflow Profile tP 10 seconds Max within 5C of 260C peak 260C Ramp up 3C/s Max 225C Ramp down not to exceed 6C/s 50 10 seconds 180C above 225C reflow area 160C 120 20 seconds in pre-heating area 25C 400 seconds Max from +25C to 260C peak 2021 Renesas Electronics Corporation 2 January 19, 2021