ib technology Data Sheet OEM-MIFARE-ICODE.PDF 7 Pages Last Revised 27/01/09 OEM-MIFARE-ICODE Reader Board The OEM-MIFARE-ICODE Reader Board is a complete Read/Write system for ISO14443A Mifare 1k, 4k, Ultralight and ISO15693 ICODE / TAG-IT cards and tags. It has an integrated PCB track antenna, LEDs, TTL serial and I/O interface and is available in two versions with RS232 connector or USB (RS232 interface version requires 5 volt supply, USB version uses USB bus for power supply). The OEM boards are based on the proven RWD-MIFARE-ICODE module design with components laid out inside a PCB track antenna and they function in exactly the same way as the module with an antenna fitted. The design incorporates power supply filtering to ensure optimum performance, antenna-trimming capacitor to adjust tuning for different environments and LEDs for visual indication of card acceptance. The J2 connector also allows the OEM-MIFARE- ICODE board to be reprogrammed with custom firmware. OEM-MIFARE-ICODE-RS232 Complete plug-and-go RFID Read / Write system based on proven design. Integrated PCB antenna, LEDS, RS232 or USB interface. Supports Mifare 1k, 4k, Ultralight and ICODE / Tag-it (including contactless read/write to Mifare ProX, SmartMX / JCOP cards). OEM-MIFARE-ICODE-USB Average current consumption down to 100A (micro Amps) even when fully active. Auxiliary output options for automatic data output as serial or Weigand protocol. Reference Design Pack available for ultra low-cost higher volume applications. This document should be read in conjunction with the MFPROT and MF ICPROT data sheets that detail the operation and command protocol for the RWD-MIFARE-ICODE modules (and therefore OEM boards also). Because they use the same design and firmware as the RWD module (and the Universal RFID base board) the Mifare Windows applications and RS232 HEX COM utility can be used in the usual manner. 1 ib technology A Reference Design Pack is also available for customers who want to copy the board layout on their own PCB and then just purchase the pre-programmed microcontroller from IB Technology. For higher volume applications this Reference Design chipset solution will achieve a proven, quick time-to-market embedded Reader product at the lowest possible cost and with minimum effort. OEM-MIFARE-ICODE-RS232 Mounting holes, 1 2 mm diameter J1 (for M2 screws) 45 mm and 70 mm 50 mm between centres. J2 1 1 75 mm OEM-MIFARE-ICODE-RS232 connectors (note Pin 1 positions on diagram), note same J2 connector and pin out as USB version. J2 connector: 2 x 6 way, TOBY boxed IDC header, 2mm pitch (www.toby.co.uk, C05-12-AG1- G), mates with TOBY A05-12 socket or equivalent. Connector J2 provides all the power, communication and control signals of the RWD-MIFARE- ICODE module on a single connector. PIN 1: GND PIN 2: OP0 PIN 3: 5v (Vcc IN) PIN 4: Red LED PIN 5: CTS (5v) PIN 6: OP1 PIN 7: GND PIN 8: Green LED PIN 9: RX (5v) PIN 10 SW1 PIN 11: Reset (MCLR) PIN 12: TX (5v) 2