TROPO 15W Dimmable LED Driver Features TROPO switch mode power supply technology is designed to generate one constant current output from an AC input, and work with industry standard lighting controls in dimming applications. 120VAC and 230VAC Inputs Available Output current availability 0.35A-1.5A. Consult Factory for customized programming Operates with Industry Standard Dimmers Compact Encapsulated Assembly Active Power Factor Correction Output Over-Voltage, Over-Current and Short-Circuit Protection and Auto Recovery High Temperature Operation (up to 90C case) UL Approved, ENEC Approved, CE Mark Long Life ROHS Compliant TROPO is designed for powering LED luminaries with standard lighting controls. The modules operate with: Standard Light Switches Triac based Incandescent Dimmers (Standard phase leading edge) Electronic Low Voltage Dimmers (Reverse Phase trailing edge) TROPO is ideal for installations requiring dimmable Class 2 outputs such as: Commercial Lighting Residential Lighting The following diagram depicts a typical installation utilizing the TROPO: Dimming range down to less then Triac 10% nominal output current Based Output current does not terminate Dimmer during off time of dimmer Output Current factory settable up to 1.5A TROPO Multiple Drivers / LED Assemblies may be connected to a single dimmer Facilitates compliance with Energy Star ratings for LED luminares TROPO 15W Dimmable LED Driver Input and Output Specification Input Voltage: 120/ 230 VAC Options: Output Voltage: 8 48 VDC (See model table for details) Model 1: 90 - 135 VAC Output Current: 0.35 to 1.5A (See model table for details) Model 2: 176 - 265 VAC 47-63 Hz Frequency Range Ripple Current: <40% (P-P) of maximum Output Current with no dimming Input Current: < 0.3A Dimming: Output dimming is possible via industry standard Efficiency: 80% Typical >120VAC, Full load dimmers *. (leading and trailing edge) Isolation: Meets the UL60950-1 Output Accuracy: +/- 5% of set point Reinforced / double Insulation Output Regulation: +/- 5% of max rating NEC (Class 2) EN60598-1 Class II Output Over-Voltage, Over-Current and Short-Circuit Protection (hiccup), Over-Temperature and Auto Recovery Input Power Factor: >0.9 (PF is >0.8 for 230VAC Models Output Control: Output Dims without any flicker. Total with output power <10W) dimming range is as follows: Input Harmonics: Meets EN61000-3-2, 3 Conduction Angle / output: 180 degrees/ 100% max 30 degrees / 10% min * Refer to Roal Tropo Application Note 1, Line Voltage Dimming of Tropo drivers, for further information. Performance Requirements: Meets the requirements of IEC 62384: control gear for LED modules EMI and EMC: Conducted and Radiated EMI: EN55015 Class B, FCC Class47CFR Part 15 Class B Susceptibility: EN61000-4-2, -3, -4, -5, -6 and -11 ANSI c62.41-1991 Category A1, 2.5kV Ringwave Eu and RoW North America ROAL Electronics S.p.A ROAL Electronics USA, Inc. Via Jesina 56/A 701 Main St., Suite 405 60022 Castelfidardo (AN) - Italy Stroudsburg, PA 18360 www.roallivingenergy.com Tel:+39 071 721461 Phone: + 1 570 421 5750 Fax:+ 39 071 72146 480 Fax: +1 570 421 5687 DS1 Tropo Plastic Rev06 - Page 2/5