TI QFP SCHMARDBOARD Description: TI QFP SCHAMRTBOARD can support MSP430(64 pins), Piccolo(64 pins) and Stellaris(48 pins) micro-controllers in QFP package with 0.5mm pitch based on the following configurations table Power/Gnd RESET EXTERNAL PROGRAMING OSCILLATOR INTREFACE MSP430 J5 J7 J8,J9 J12,J13,J20 Piccolo J19 J7 J8,J9 J10,J15 Stellaris J6 J7 J8,J9 J17,J18 Features: On board 3.3V regulator (max DC 12V input, 2.1mm power jack pole diameter) On board reset circuit External clock options: Crystal (Y1, C1, C2) option Fully access each pin of the chip Schmart-EZ Soldering Technology Dimensions: 4 X 4 Hand solder your chip as per the enclosed SchmartBoard ez instructions, solder headers for the pin out and then configure the board jumpers based on your micro controller type MSP430 A type configuration MSP430x1xx 8MHz Series (64 pin), MSP430x2xx 8MHz Series (64 pin) and MSP430x4xx 8/16MHz LCD Series (64pin) are supported except MSP430FX2 series 1. Put jumpers on J5(2X6 header) as following picture for POWER/GND 2. Put jumpers on J7(2X3 header) as following picture for RESET 3. Put headers/jumpers on J8(2X3 header) and J9(2X3 header) as following picture if an external oscillator is used 4. For SBW programming mode put header/jumpers on J13(2X2 header), and no jumpers on J12(2X5 header). For JTAG programming mode put headers/jumpers on J12, and no jumpers on J13 5. J20 configuration depend on the type of programmer or debugger. Please see the following picture for the configuration 6. J11(2X7 header) is the JTAG/SBW programming interface